Agilent Technologies 6611C, 6634B, 66332A SOURceDIGitalDATA, SOURceDIGitalFUNCtion, SOURceVOLTage

Language Dictionary - 4

[SOURce:]DIGital:DATA

This command sets and reads the dc source digital control port when that port is configured for Digital I/O operation. The port has three signal pins and a digital ground pin. Pins 1 and 2 are output pins controlled by bits 0 and 1. Pin 3 is controlled by bit 2, and can be programmed to serve either as an input or an output. It normally serves as an output. Bit 2 must be programmed high to use pin 3 as an input. Pin 4 is the digital ground. The query returns the last programmed value in bits 0 and 1 and the value read at pin 3 in bit 2.

Program

Value

0

1

2

3

4

5

6

7

Bit Configuration

2		1	0
0		0	0
0		0	1
0		1	0
0		1	1
1		0	0
1		0	1
1		1	0
	1	1	1

	Pin Setting
4	3	2	1
GND Output		Lo	Lo
GND Output		Lo	Hi
GND Output		Hi	Lo
GND Output		Hi	Hi
GND	Intput	Lo	Lo
GND	Intput	Lo	Hi
GND	Intput	Hi	Lo
GND	Intput	Hi	Hi

Command Syntax	[SOURce]:DIGital:DATA[:VALue] <NRf>
Parameters	0 to 7
*RST Value	0
Examples	DIG:DATA 7
Query Syntax	[SOURce]:DIGital:DATA?
Returned Parameters	<NR1>
Related Commands	DIG:FUNC

[SOURce:]DIGital:FUNCtion

This command configures the dc source digital control port. The configuration setting is saved in non- volatile memory.

RIDFi	Configures the port for Remote Inhibit/Discrete Fault Interrupt operation
DIGio	Configures the port for Digital input/output operation (see DIG:DATA)
	Command Syntax	[SOURce]:DIGital:FUNCtion <CRD>
	Parameters	RIDFi DIGio
	Examples	DIG:FUNC DIG
	Query Syntax	[SOURce]:DIGital:FUNC?
	Returned Parameters	<CRD>
	Related Commands	DIG:DATA

[SOURce:]VOLTage

This command sets the output voltage level of the dc source.

Command Syntax	[SOURce]:VOLTage[:LEVel][:IMMediate][:AMPLitude]<NRf+>
Parameters	see Table 4-3
Default Suffix	V (volts)
*RST Value	0
Examples	VOLT 2	VOLTAGE:LEVEL 200 MV
Query Syntax	[SOURce]:VOLTage[:LEVel][:IMMediate][:AMPLitude]?
Returned Parameters	<NR3>
Related Commands	VOLT:TRIG

59