Epson TM-T85P manual ➀ GS V m ➁ GS V m n, 2ASCII

➁ Command using y: ESC 3, ESC J

•In page mode, the following commands use x or y, depending on character orientation:

➀ When the print starting position is set to the upper left or lower right of the printing area using ESC T (data is buffered in the direction perpendicular to the paper feed direction):

Command using x: ESC SP, ESC $, ESCW, ESC\

Command using y: ESC 3, ESC J, ESC W, GS $, GS\

➁ When the print starting position is set to the upper right or lower left of the printing area usinhg ESC T (data is buffered in the paper feed direction):

Command using x: ESC 3, ESC J , ESC W, GS $, GS\

Command using y: ESC SP, ESC $, ESC W, ESC\

•This command does not affect the previously specified values.

•The calculated result from combining this command with others is turncated to the minimum value of the mechanical pitch or an exact multiple of that value.

[Default] x = 180, y = 360

[Reference] ESC SP, ESC $, ESC 3, ESC J, ESC W, ESC \, GS $, GS L, GS W,

GS \

➀GS V m ➁ GS V m n

[Name]	Select cut mode and cut paper
[Format]	1ASCII	GS	V	m
	Hex	1D	56	m
	Decimal	29	86	m
	2ASCII	GS	V	m	n
	Hex	1D	56	m	n
	Decimal	29	86	m	n
[Range]	10 ≤ m ≤ 1, 48 ≤ m ≤ 49
	265 ≤ m ≤ 66, 0 ≤ n ≤ 255

[Description] Selects a mode for cutting paper and executes paper cutting. The value of m selects the mode as follows:

mPrint mode

0, 48	Full cut (cutting completely)
1, 49	Partial cut (one point left uncut)
65	Feeds paper for (cutting position + [n ✕ (vertical motion unit)]), and cuts the
	paper completely.
66	Feeds paper for (cutting position + [n✕ (vertical motion unit)]), and cuts the
	paper partially(one point left uncut).

[Note for ➀ and ➁]

Commands 5-43