Epson TM-T85P manual Name Transmit paper sensor status Format

[Description] Transmits the status of connector pin n, using n as follows:

n

0, 48

Connector pin

Drawer kick-out connector pin 3

[Notes]		• When DTR/DSR control is selected, the printer transmits only 1
			byte after confirming that the host is ready to receive data (DSR
			signal is SPACE). If the host computer is not ready to receive data
			(DSR signal is MARK), the printer keeps waiting until the host is
			ready. When XON/XOFF control is selected, the printer transmits
			only 1 byte without checking the DSR signal.
		• This command is executed when the data is processed in the
			receive buffer. Therefore, there may be a time lag between
			receiving the command and transmitting the status, depending on
			the receive buffer status.
		• When Auto Status Back (ASB) is enabled using GS a, the status
			transmitted by ESC u and the ASB status must be differentiated.
		• When the connector is not used, the value of bit 0 is always 1.
		• The status to be transmitted is shown in the table below.
Bit	Off/On			Hex		Decimal		Function
0	Off			00		0		Level of pin 3 is Low.
	On			01		1		Level of pin 3 is High.
1	-			-		-		Undefined.
2	-			-		-		Undefined.
3	-			-		-		Undefined.
4	Off			00		0		Not used. Fixed to Off.
5	-			-		-		Undefined.
6	-			-		-		Undefined.
7	Off			00		0		Not used. Fixed to Off.
[Reference] DLE EOT, GS a, GS r
ESC v
[Name]		Transmit paper sensor status
[Format]		ASCII			ESC		V
		Hex			1B		76
		Decimal			27		118
[Description]		Transmits the current paper sensor status.

Commands 5-33