| • The distance from the beginning of the line to the print position is | |
| [(nL + nH ✕ 256) ✕ (vertical or horizontal motion unit)] inches. | |
[Notes] | • Settings outside the specified printable area are ignored. | |
| • The horizontal and vertical motion unit are specified by GS P. | |
| • The GS P command can change the horizontal (and vertical) | |
| motion unit. However, the value cannot be less than the minimum | |
| horizontal movement amount, and it must be in even units of the | |
| minimum horizontal movement amount. | |
| • In standard mode, the horizontal motion unit (x) is used. | |
| • In page mode, horizontal or vertical motion unit differs | |
| depending on the starting position of the printable area as follows: | |
| 1 | When the starting position is set to the upper left or lower right |
|
| of the printable area using ESC T, the horizontal motion unit (x) |
|
| is used. |
| 2 | When the starting position is set to the upper right or lower left |
|
| of the printable area using ESC T, the vertical motion unit (y) is |
|
| used. |
[Reference] ESC \, GS $, GS \, GS P