Epson TM-T85P manual ESC T n, Paper feed direction

•This command switches the settings for the following commands (in which the values can be set independently in standard mode and page mode) to those for standard mode:

➀ Set right-side character spacing: ESC SP

➁Select 1/6-inch line spacing: ESC 2

➂ Set line spacing: ESC 3

[Reference] FF, ESC FF, ESC L

ESC T n

[Name]	Select print direction in page mode
[Format]	ASCII	ESC	T	n
	Hex	1B	54	n
	Decimal	27	84	n
[Range]	0 ≤ n ≤ 3
	48 ≤ n ≤ 51

[Description] Selects the print direction and starting position in page mode. n specifies the print direction and starting position as follows:

n	Print Direction	Starting Position
0, 48	Left to right	Upper left
		(A in the figure)
1, 49	Bottom to top	Lower left
		(B in the figure)
2, 50	Right to left	Lower right
		(C in the figure)
3, 51	Top to bottom	Upper right
		(D in the figure)

A		D
	Printing area
		C
B

Paper feed direction

[Notes]	• When the command is input in standard mode, the printer
	executes only internal flag operation. This command does not
	affect printing in standard mode.
	• This command sets the position where data is buffered within the
	printing area set by ESC W.
	• Parameters for horizontal or vertical motion units (X or y ) differ as
	follows, depending on the starting position of the printing area:
	➀ If the starting position is the upper left or lower right of the
	printing area, data is buffered in the direction perpendiccular to
	the paper feed direction:
	Commands using horizontal motion units: ESC SP, ESC $,
	ESC \
	Commands using vertical motion units: ESC 3, ESC J, GS $,
	GS \

Commands 5-23