XES COMMANDS | Page415- |
The “Font Delete” command is a job boundary command that deletes specified fonts from those already downloaded, where fontname is the name of the font entered exactly as it appears on the Configuration/Status Page, and where each fontname is separated by a comma. This command also deletes the current merge page from memory. Printer default or system fonts cannot be deleted.
Font ID Assignment
▲COMMAND: s+#fontnamed
▲RANGE: 0-9
This command assigns an ID number to a font, where # is a numeral between 0 and 9, and where fontname is the name of the font entered exactly as it appears on the Configuration/Status Page. Once assigned, the ID number is used to call up a font in storage. This is not a job boundary.
When the user implements this command, the assigned font (resident in the XLi’s FLASH memory) is downloaded to the printer.
Font Change
▲COMMAND: s#
▲RANGE: 0-9
The “Change Font” command causes all subsequent data to be printed in the new font until a “Reset” or another “Change Font” command is received, where # is the ID of the font as assigned by the command “Font ID Assignment.”
Page Formatting Commands
This section describes the commands that control page formatting, including margins, tabs, line spacing and measurement units. Margins, tabs and page size settings are dependent upon the unit of measurement selected by the “Units” commands directly below.
Units — 1/60"
▲COMMAND: szg