AMT Datasouth 4000 manual Set-up Mode Selection Items, Range Factory Default Remarks

Set-up Mode Selection Items

Item	Range	Factory Default	Remarks
CUT/PEEL POS (mm)	+ 015 to + 015	0 mm	Controls cut and peeling position.
PRINT OFFSET (mm)	+ 015 to - 008	0 mm	Controls start vertical print position.
			Positive value only.
TPH VER OFFS(mm)	+ 003 to - 003	0 mm
RECOVERY PRINT	ENABLE	ENABLE
	DISABLE
1GAP HEIGHT	MORE THAN 10,	MORE THAN 10
	5 to 7 mm,	mm
	8 to 9 mm.
2CUTTER ROTATION	NORMAL (~4”),	NORMAL (~4”)	2”, 3” and 4”(inches) stand for the
	MORE (<3”),		label width. Setting proper width can
	MORE (<2”)		avoid jam.
2CUTTER TYPE	TYPE I,	TYPE I	Enable the type of cutter mechanism
	TYPE II		is installed
COMPRESSED FLASH	NO	NO
	COMPRESSION,	COMPRESSION
	COMPRESSED
WIN CON LEN (mm)	0 to 254 mm	0 mm	This takes effect only when you run
			under Windows with bundled printer
			driver and use continuous media.
BASE SPEED (IPS)	0 to 4 IPS	0 IPS	This is for the PPLB emulation only.
			When you choose TLP2642/3642
			driver the speed is limited under 2
			ips.
COUNTER ON LCD	ENABLED,	ENABLED
	DISABLED
MEDIA SENS. TYPE	REFLECTIVE	REFLECTIVE	Select the proper type by the media
	SEE-THROUGH		characteristics. Do calibration before
			printing.
2CUTTER SIGNAL	CHECKED,	CHECKED	For general media, set it to
	IGNORED		“CHECKED” except for thick media.
BACKFEED	DISABLE,	DISABLE	This feature enables a manual
	ENABLE		Present function. It can be disabled
			by a software command.
3BACK DISTNCE(mm)	010 to 040	012	This is the distance the printer will
			move the form to a Presentation
			position.

1

2

3

Displayed only when Switch 4 is on. Displayed only when Switch 3 enabled

Displayed only when the BACKFEED feature is enabled.

User's Guide 41