Siemens CL-110 user manual Troubleshooting, Problems with LAN, Problems with WAN

Page 101

Chapter 5:Troubleshooting

Chapter 5: Troubleshooting

If the suggested solutions in this section do not resolve your issue, contact your system administrator or Internet service provider.

Problems with LAN

PCs on the LAN cannot get IP addresses from the ADSL Router.

The chances are that the interface used as DHCP server is modified and the client PCs do not renew IP addresses.

If your DHCP server is enabled on Private IP Address previously and you modify the interface to Public IP Address, the client PCs should renew IP addresses.

The PC on the LAN cannot access the Web page of the ADSL Router. Check that your PC is on the same subnet with the ADSL Router. The virtual server can’t be access after setting virtual server.

Check the filter rule of the port that virtual server service setting for example, the virtual server service set FTP 21 you need update the filter rule of the ftp 21 Direction setting: Choose filter the packets that incoming action (In Bound) are Allow on the interface.

Problems with WAN

You cannot access the Internet.

…Check the physical connection between the ADSL Router and the LAN.

If the LAN LED on the front panel is off or keeps blinking, there may be problem on the cable connecting to the ADSL Router.

At the DOS prompt, ping the IP address of the ADSL Router, e.g, ping 192.168.1.1. If the following response occurs:

Relay from 192.168.1.1 bytes=32 time=100ms TTL=253

Then the connection between the ADSL Router and the network is OK.

If you get a failed ping with the response of:

Request time out

Then the connection is fail. Check the cable between the ADSL Router and the network.

…Check the DNS setting of the ADSL Router.

At the DOS prompt, ping the IP address of the DNS provided by your ISP. For example, if your DNS IP is 168.95.1.1, then ping 168.95.1.1. If the following response occurs:

Relay from 168.95.1.1 bytes=32 time=100ms TTL=253

Then the connection to the DNS is OK.

If you get a failed ping with the response of:

Image 101
Contents Rev 2006/02/09 User’s ManualSafety Notes FCC Preface FeaturesRouting Features Bridging FeaturesSecurity Features Configuration and ManagementUnpacking Subscription for Adsl Service Page Overview LED IndicatorsPhysical Outlook Front PanelVAC Rear PanelChoosing a place for the Adsl Router System Requirement and InstallationSystem Requirement Connecting the Adsl Router For Windows Install the USB DriverFor Windows ME Page For Windows XP Page Uninstall the USB Driver For Windows Configuration Page Configuration For Windows XP Configuration Page Setting TCP/IP Option 1 If you have no TCP/IP protocol, click Add Configuration Page For Windows ME Highlight TCP/IP Protocol and click OK For Windows NTConfiguration Page For Windows Page Panel and then click Network Internet Connections Option 1 If you have no TCP/IP Protocol, click InstallProperties Click Internet ProtocolTCP/IP and then click OKConfigure PC to get IP address from Dhcp Enable Obtain an IP address automatically and then click OK For Windows 98ME Renew IP Address on Client PCFor Windows NT For Windows Configuration Connecting and Accessing Internet Description PPP over ATM PPPoA ModeConfiguration Go to Advanced Internet Connections. And click Add PPP over ATM PPPoA IP Extension ModeISP PPP over Ethernet PPPoE ModePPP over Ethernet PPPoE IP Extension Mode Numbered IP over ATM IPoA IP Address Subnet Mask Gateway Numbered IP over ATM IPoA+NAT LAN Primary DNS server Secondary DNS server Unnumbered IP over ATM IPoAIP Address Subnet Mask Gateway Primary IP Address Subnet mask Unnumbered IP over ATM IPoA+NATPage Bridge Mode Using Web-Based Manager Web ConfigurationLanguage To Have the New Settings Take EffectOutline of Web Manager Quick Start Quick SetupConnect to Internet Connection TypeConnection Mode Choose PPPoA or PPPoE and click Next PPP over ATM/ PPP over EthernetPPP Username PPP PasswordAlways On Dial on DemandDhcp Server Off Leased TimeNone IP over ATMSubnet Mask Connection Mode Bridging MTU Overview StatusAdsl BER Test Adsl LineTraffic Statistics Internet ConnectionDhcp Table Routing TableConnection Mode Local Network Dhcp Server Advanced SetupLocal Network- IP Address Server and Relay Off Relay OnPage Local Network UPnP Internet-Connections SettingAdding a New One VPI Virtual Path IdentifierPage Internet-DNS Server Igmp Proxy EnabledInternet-IGMP Proxy Internet ConnectionIP Routing Static Route Internet Adsl SettingsGateway IP Address Configuring Other Routers on Your LANRemove Static Route DestinationEnabled Operation ModeIP Routing Dynamic Routing Adsl RouterConnection Mode Virtual Server-Port Forwarding User defined IP Address seen by Internet UsersPre-defined From Internet Host IP Address Connecting to the Virtual ServersVirtual Server-Port Triggering Virtual Server DMZ Host Virtual Server Dynamic DNS Select the direction to filter packets FirewallFiltering by IP address Protocol Allow TrafficSource/Destination IP address Port RangeBridge QoS Quality of ServiceIPQoS IP type of ServiceSource IP Address/ Subnet Mask Source PortVoice Quality Port MappingDestination Port Available Interfaces Group NameManagement DiagnosticsRemote Access Admin AccountSystem Log Configure System LogInterntet Time Viewing System Log Snmp Setting Reset Router Backup ConfigUpdate Firmware UPnP for XP Page Problems with WAN TroubleshootingProblems with LAN Problems with Upgrading Glossary ARP Address Resolution ProtocolVPI Virtual Path Identifier & VCI Virtual Channel Identifier Glossary Page Interface One RJ-11 port for Adsl connection Appendix a SpecificationsPage Getting Client Certificate Appendix B Server Setup for 802.1x ClientYes Appendix C Weee B2C