Siemens CL-110 user manual Configuration

Page 31

Chapter 3: Configuration

5.Click Yes to use DHCP.

6.Insert the Windows NT CD into your CD-ROM drive and type the location of the CD. Then click Continue.

7.Returning to the Network window, you will find the TCP/IP Protocol among the list. Select TCP/IP Protocol and click Properties.

8.Enable Specify an IP address option. Enter the IP Address: 192.168.1.x (x is between 2 and 254) and Subnet Mask: 255.255.255.0 and Default Gateway: 192.168.1.1 as in figure below.

Image 31
Contents Rev 2006/02/09 User’s ManualSafety Notes FCC Preface FeaturesConfiguration and Management Bridging FeaturesRouting Features Security FeaturesUnpacking Subscription for Adsl Service Page Front Panel LED IndicatorsOverview Physical OutlookVAC Rear PanelSystem Requirement System Requirement and InstallationChoosing a place for the Adsl Router Connecting the Adsl Router For Windows ME Install the USB DriverFor Windows Page For Windows XP Page Uninstall the USB Driver For Windows Configuration Page Configuration For Windows XP Configuration Page Setting TCP/IP Option 1 If you have no TCP/IP protocol, click Add Configuration Page For Windows ME Highlight TCP/IP Protocol and click OK For Windows NTConfiguration Page For Windows Page Click Internet ProtocolTCP/IP and then click OK Option 1 If you have no TCP/IP Protocol, click InstallPanel and then click Network Internet Connections PropertiesConfigure PC to get IP address from Dhcp Enable Obtain an IP address automatically and then click OK For Windows 98ME Renew IP Address on Client PCFor Windows NT For Windows Configuration Connecting and Accessing Internet Configuration PPP over ATM PPPoA ModeDescription Go to Advanced Internet Connections. And click Add PPP over ATM PPPoA IP Extension ModeISP PPP over Ethernet PPPoE ModePPP over Ethernet PPPoE IP Extension Mode Numbered IP over ATM IPoA IP Address Subnet Mask Gateway Numbered IP over ATM IPoA+NAT LAN Primary DNS server Secondary DNS server Unnumbered IP over ATM IPoAIP Address Subnet Mask Gateway Primary IP Address Subnet mask Unnumbered IP over ATM IPoA+NATPage Bridge Mode Using Web-Based Manager Web ConfigurationOutline of Web Manager To Have the New Settings Take EffectLanguage Connection Type Quick SetupQuick Start Connect to InternetConnection Mode Choose PPPoA or PPPoE and click Next PPP over ATM/ PPP over EthernetDial on Demand PPP PasswordPPP Username Always OnDhcp Server Off Leased TimeNone IP over ATMSubnet Mask Connection Mode Bridging MTU Overview StatusAdsl BER Test Adsl LineRouting Table Internet ConnectionTraffic Statistics Dhcp TableConnection Mode Local Network- IP Address Advanced SetupLocal Network Dhcp Server Server and Relay Off Relay OnPage VPI Virtual Path Identifier Internet-Connections SettingLocal Network UPnP Adding a New OnePage Internet Connection Igmp Proxy EnabledInternet-DNS Server Internet-IGMP ProxyIP Routing Static Route Internet Adsl SettingsDestination Configuring Other Routers on Your LANGateway IP Address Remove Static RouteAdsl Router Operation ModeEnabled IP Routing Dynamic RoutingConnection Mode Virtual Server-Port Forwarding Pre-defined IP Address seen by Internet UsersUser defined Virtual Server-Port Triggering Connecting to the Virtual ServersFrom Internet Host IP Address Virtual Server DMZ Host Virtual Server Dynamic DNS Filtering by IP address FirewallSelect the direction to filter packets Port Range Allow TrafficProtocol Source/Destination IP addressBridge QoS Quality of ServiceSource Port IP type of ServiceIPQoS Source IP Address/ Subnet MaskDestination Port Port MappingVoice Quality Available Interfaces Group NameManagement DiagnosticsRemote Access Admin AccountInterntet Time Configure System LogSystem Log Viewing System Log Snmp Setting Update Firmware Backup ConfigReset Router UPnP for XP Page Problems with LAN TroubleshootingProblems with WAN Problems with Upgrading Glossary ARP Address Resolution ProtocolVPI Virtual Path Identifier & VCI Virtual Channel Identifier Glossary Page Interface One RJ-11 port for Adsl connection Appendix a SpecificationsPage Getting Client Certificate Appendix B Server Setup for 802.1x ClientYes Appendix C Weee B2C