
■In a hot swap extraction, you may be required to enter software commands before and after the extraction to detach the adapter from the system correctly.
■In a cold extraction, you must shut down the system’s operating system and power down the system before extracting the adapter.
Note
▼To Extract the Adapter from a Hot Swap Environment
1.Start cPCI hot swap.
%drvconfig
2.As superuser, identify the cPCI card to be removed. You must know the slot number (attachment point ID).
#cfgadm pci
I/O assemblies are indicated by
3.Detach (unconfigure) the cPCI card to be removed.
#cfgadm
where attachment_point is pcischxxx.
4.Repeat the attachment point list to confirm the board detachment.
#cfgadm pci
5.Check that the blue LED is on.
The Removal OK LED must change from green to amber to signal the unconfigured state. When the Removal OK LED is amber, it is safe to remove the cPCI card.
20 SunATM 3U CompactPCI Adapter Installation and User’s Guide • February 2001