Sun Microsystems 3U manual Editing SunATM Configuration Files

C H A P T E R 5

Editing SunATM Configuration

Files

This chapter describes how to configure SunATM interfaces by editing the configuration files.

You are not required to edit these configuration files by hand. You can use the atmadmin configuration program, described in “Using the atmadmin Configuration Program” on page 24, to configure the SunATM files. From the program’s command- line interface, you can change most of the SunATM parameters.

Caution –When the atmadmin program saves configuration information, it overwrites the existing SunATM configuration files in the /etc/opt/SUNWconn/atm/ directory. Therefore, any comments or other changes you made to the files by hand will be lost.

This chapter contains the following sections:

■“Editing the atmconfig File” on page 42

■“Configuring a Classical Internet Protocol Interface” on page 44

■“Configuring a LAN Emulation Interface” on page 53

■“Supporting Multiple Emulated LANs on a Single Interface” on page 58

41