Interface Configuration Menu

Once you select a SunATM interface, you will see the atmadmin Interface Configuration menu. From this menu you can proceed to the interface parameter group submenus, which are described in “atmadmin Parameter Groups” on page 28. You can use these sub-menus to change the SunATM interface configuration parameters.

Modifying ba0

[Y]Physical Layer

[U]UNI Signalling

[I]ILMI Address Registration

[C]Classical IP

[L]LAN Emulation

[P]Previous Menu

[M]Main Menu

[X]Exit [?] Help

Enter selection:

atmadmin and the SunATM Configuration Files

The atmadmin program first attempts to read the current configuration information from the following directories

/etc/opt/SUNWconn/atm/atmconfig

/etc/opt/SUNWconn/atm/aarconfig

/etc/opt/SUNWconn/atm/laneconfig

If no configuration information is found, or if the files do not exist, the default values listed in TABLE 4-2are applied to the installed interfaces.

Caution When saving configuration information, atmadmin overwrites the existing SunATM configuration files in the /etc/opt/SUNWconn/atm directory. Therefore, any comments or other changes you manually made to the files will be lost.

Chapter 4 Configuring the SunATM Interfaces 27

Page 49
Image 49
Sun Microsystems 3U manual Interface Configuration Menu, Atmadmin and the SunATM Configuration Files