aarsetup: waiting for ilmid to provide prefix
lanesetup: waiting for ilmid to provide prefix
In some cases, the address registration process may take several minutes. If so, aarsetup or lanesetup prints out this message saying that it cannot complete until address registration completes. If the messages continue for more than a minute or two, verify your connection to the switch, and that the switch and interface are both supporting ILMI.
undefined variable
You used a variable in a configuration file without using a set statement to assign the value. Add a set statement, or correct the variable name, and run aarsetup or lanesetup again. See “Using Variables in the aarconfig File” on page 47, and “Using Variables in the laneconfig File” on page 56, for more information.
variable already defined
You tried to set a variable that had been previously set in the same configuration file. Remove the second assignment and run aarsetup or lanesetup again.
variable name
You created a variable in /etc/opt/SUNWconn/atm/aarconfig or /etc/opt/ SUNWconn/atm/laneconfig that was syntactically invalid. Variable names are a combination of letters, digits, and underscores (_). Choose a conforming variable name and run aarsetup or lanesetup again.
variable name too long
You created a variable in /etc/opt/SUNWconn/atm/aarconfig or /etc/opt/ SUNWconn/atm/laneconfig with a name that is greater than the maximum length (32 characters). Choose a variable name shorter than 32 characters and run aarsetup or lanesetup again.
variable value too long
You assigned a value longer than the maximum value length of 128 characters to a variable in a configuration file. If you want a longer value, use a combination of variable names, with each value less than 128 characters. After correcting the variable value lengths, run aarsetup or lanesetup again.
ifname:cannot join ELAN (frame size too large; please use a different ELAN and rerun lanesetup)
The largest MTU size supported by the SunATM software is 9 kilobytes. If the LAN Emulation Services try to set a size larger than 9 Kbytes, the SunATM client cannot join the emulated LAN. Reset your LAN Emulation services to use an MTU size less than or equal to 9 Kbytes, and rerun lanesetup to join the emulated LAN.
114 SunATM 3U CompactPCI Adapter Installation and User’s Guide • February 2001
