Sun Microsystems 3U manual Ok setenv diag-switch? false ok setenv auto-boot? true

7.Using the test command and the device path found in Step 6, start the adapter’s

FCode self-test.

ok test device path

Refer to the OpenBoot Command Reference Manual for more information on the test command.

If all of the tests pass, you will see these messages:

ok test /pci@if,0/pci@1/pci@1/pci@a/SUNW,ma@0 Register Test -- succeeded.

Memory Test -- succeeded.

SAHI Internal Loopback Test -- succeeded. SUNI Internal Loopback Test -- succeeded. ok

If the adapter fails a test, you will see an error message (in this example, the Register test failed):

ok test /pci@if,0/pci@1/pci@1/pci@a/SUNW,ma@0 Register Test -- failed.

Memory Test -- succeeded.

SAHI Internal Loopback Test -- succeeded. SUNI Internal Loopback Test -- succeeded. ok

Note –If the test command fails, verify that the adapter hardware is installed correctly. If necessary, replace the adapter or contact your service provider for support.

8.After testing the adapter, type the following commands to return the OpenBoot PROM to the standard operating mode.

ok setenv diag-switch? false ok setenv auto-boot? true

84 SunATM 3U CompactPCI Adapter Installation and User’s Guide • February 2001