If you have to reinstall the card, be sure to follow the instructions outlined in your system’s service manual for the removal and replacement of I/O cards.
Refer to the system documentation for additional troubleshooting instructions.
▼To Power On the System After a Cold Installation
1.Before powering on the system, make sure that all the cables are connected and the peripheral devices are powered on.
2.Follow the appropriate procedures, as documented in the system’s hardware installation manual, to power on the system.
Refer to the system’s documentation for the complete
3.Check the hot swap LED on the adapter.
■If the adapter was installed correctly, the blue LED should be off.
■If the hot swap LED remains on (lit), the adapter was not installed correctly. Remove and reinstall the adapter to make sure it is seated correctly in the slot.
If you have to reinstall the card, be sure to follow the instructions outlined in your system’s service manual for the removal and replacement of I/O cards.
Refer to the system documentation for additional troubleshooting instructions.
4.Verify that the system’s power LED is on (lit), indicating that the system has completely powered on.
Extracting the Adapter
The adapter is a
Determining the Type of Adapter Extraction
Determine whether you want to perform a hot swap extraction of the adapter or a cold extraction.
Chapter 3 Installing and Extracting the Adapter 19
