
Attaching the Adapter to the System
After installing the adapter, you must make the system recognize the new adapter and its interfaces. The procedure you use for attaching the adapter to the system depends on whether you installed the adapter in a hot swap or cold environment.
If you performed a hot installation, see “To Attach the Adapter in a Hot Swap Environment” on page 18. If you powered down the system before installing the card, see “To Power On the System After a Cold Installation” on page 19.
Note
▼To Attach the Adapter in a Hot Swap Environment
1.Follow the hot swap procedures for attaching an I/O card to the system in the system’s documentation.
Refer to the system’s server or hardware installation manual for the attachment procedure specific to your system.
2.On some systems, for example, you would log into the system console as superuser and identify the board slot number (attachment point).
#cfgadm
3.At the system console, activate the adapter with the cfgadm
#cfgadm
Where ap_id is the attachment point ID.
4.Check the hot swap LED on the adapter.
■If the adapter was installed correctly, the blue LED should be off.
■If the hot swap LED remains on (lit), the adapter was not installed correctly. Remove and reinstall the adapter to make sure it is seated correctly in the slot.
18 SunATM 3U CompactPCI Adapter Installation and User’s Guide • February 2001