If you choose Non Realtime VBR, you have to type in the following data.
The range for Peak Cell Rate is from 1 to 1690.
The range for Sustainable Cell Rate is from
1 to 1689 and must be smaller than Peak Cell Rate.
The range for Maximum Burst Size is from 1 to 100.
After click Next, you will see the web page listed as the right. Choose the protocol that you want. And click Next again.
The WAN IP settings will differ slightly according to the protocol that you choose. This graphic is the one that you will get if you choose to add a new interface of PPPoA/PPPoE mode. You can check Enable NAT or Enable Qos for your necessity. And you can set the MTU value in this page.
If you want to add a new interface of PPPoE mode and choose PPPoE from the previous web page, you will get a web page as the graphic listed in right side.
Please refer to Quick Setup for more information if you don’t know how to set the configuration.
If you want to add a new interface of Bridging mode and choose Bridging from the previous web page, you will get a web page as the graphic listed in right side.
Please refer to Quick Setup for more information if you don’t know how to set the configuration.