Wacom PL-521, DTF-521 manual Handling, Hg Lamps Inside this Product Contain Mercury and Must be

Page 5

DTF521_Manual.fm Page 3 Tuesday, February 28, 2006 10:36 AM

Handling

WARNING

High Voltage. Do not open or disassemble the DTF-521/PL-521 pen display.

 

 

There is a risk of electrical shock when the casing is open. This will also void your

 

 

 

 

warranty and Wacom shall have no responsibility to repair or replace the product.

WARNING

If the LCD screen has been damaged, DO NOT touch any liquid that may be leaking

 

 

from it; this liquid is an irritant. In case of contact with skin, eyes, or mouth, rinse

 

 

 

 

immediately with running water for at least 15 minutes or more. If contact is made with the

 

 

eyes or mouth, also consult a physician.

WARNING

Hg – LAMP(S) INSIDE THIS PRODUCT CONTAIN MERCURY AND MUST BE

 

 

 

 

 

 

RECYCLED OR DISPOSED OF ACCORDING TO LOCAL, STATE OR FEDERAL

 

 

LAWS.

 

 

The DTF-521/PL-521 pen display has a backlight which contains mercury (Hg). Be sure

 

 

to dispose of properly, and to manage any disposal of this unit in accordance with your local

 

 

ordinances and laws.

WARNING

Prevent children from swallowing the pen tip or side switch. The pen tip or side switch

 

 

may accidentally be pulled out if children are biting on them.

 

 

CAUTION

Do not disassemble the pen. This may cause the device to malfunction. In this case,

 

 

Wacom shall have no responsibility to repair or replace the product.

CAUTION

Do not scratch the display screen. Avoid placing sharp objects on the display screen

 

 

surface.

CAUTION

When adjusting the tilt angle of the pen display, be careful to avoid catching your

 

 

finger in the gap of the movable portion of the stand.

CAUTION

Do not lift the DTF-521/PL-521 by the stand; this may damage the stand mechanism.

 

 

When lifting or moving the pen display, always do so by grasping the main body casing.

CAUTION

Avoid intensive shock or vibration to the DTF-521/PL-521 or the pen. Hitting or dropping

 

 

the pen display may damage the display screen or other components.

CAUTION

Do not put heavy articles on the pen display or push against it with a strong force; this

 

 

may damage the display screen or bend the stand.

CAUTION

Do not place heavy articles on the DTF-521/PL-521 cabling, repeatedly bend the cables

 

 

sharply, or apply heavy stress to the cable connectors; this may damage the unit or

 

 

cabling.

CAUTION

If the pen tip becomes sharp or angular, it may damage the coating on the display

 

 

screen. Please replace the pen tip if necessary.

CAUTION

Do not use any organic solvent (e.g., alcohol) or even mild detergent to clean

 

 

the display screen. Use of these cleaners can damage the coating on the screen.

 

 

Please note that damage of this kind is not covered by the manufacturer's warranty.

 

 

• To clean the display screen, use an anti-static cloth or a slightly damp cloth.

 

 

When cleaning, apply only a light amount of pressure to the display screen and do not

 

 

make the surface wet.

 

 

• To clean the pen display casing or pen, use a soft cloth with mild detergent (such as dish

 

 

washing liquid) diluted with water.

Precautions on use and handling page 3

Image 5
Contents Pen Display This page intentionally left blank Introduction and Overview Temperature and humidity Precautions on USE and HandlingPhysical location EnvironmentHg Lamps Inside this Product Contain Mercury and Must be HandlingDTF521Manual.fm Page 4 Tuesday, February 28, 2006 1036 AM Contents Unpacking Your PEN Display Package contentsFront view PEN Display ComponentsRear view System requirements InstallationVGA connector LCD monitor installationAdapter may damage the unit LCD monitor cabling diagramDTF521Manual.fm Page 12 Tuesday, February 28, 2006 1036 AM Pen tablet cabling diagram Pen tablet installationUSB cable installation Next steps Software installationWorking with Your PEN Display Setting up your work areaPen components Using the penPen operations Opening the control panel CustomizingCustomizing the pen Control panel overviewCalibrating your pen display Control panel details Adjusting double-clickCustomizing the side switch button functions DTF521Manual.fm Page 22 Tuesday, February 28, 2006 1036 AM DTF521Manual.fm Page 23 Tuesday, February 28, 2006 1036 AM Factory presets, auto-sync, and user settings Adjusting the LCD monitorWorking with on screen display settings Enter buttonMenu Position DTF521Manual.fm Page 26 Tuesday, February 28, 2006 1036 AM Adjusting pitch and phase Video Power consumption Power savingPower saving mode Sync If there is no display TroubleshootingTesting the DTF-521/PL-521 Verify that the tablet and pen are working General display problems Display troubleshootingDisplay ripples or flickers VGA problemsGeneral problems Pen tablet troubleshootingTroubleshooting on DTF521Manual.fm Page 35 Tuesday, February 28, 2006 1036 AM Windows XP Windows-Specific ProblemsSupport. See Technical support options on Macintosh-Specific ProblemsTechnical support options Asia Pacific English China Obtaining driver downloadsJapan Appendix CleaningCaring for your pen display Replacing the pen tipUsing an alternate mount or stand Windows XP or XP Uninstalling the DTF-521/PL-521Windows 98SE, Me, or Macintosh OSLCD monitor Product specificationsGeneral specifications Power adapter Purchasing parts and accessoriesPen tablet Pen model FP-320CE declaration Radio and television interferenceFederal Communications Commission FCC notice Warranty North and South America contact Warranty Service in the U.S.A. and CanadaWarranty Service Outside of the U.S.A. and Canada Europe, Africa and Middle East Software License Agreement License and WarrantyEntitlement to Use the Software Important Notice to CustomersGermany This page intentionally left blank Appendix