Wacom DTF-521, PL-521 manual Rear view

DTF521_Manual.fm Page 8 Tuesday, February 28, 2006 10:36 AM

Rear view

Pen storage compartment

For storage, insert one end of the pen into either side of the storage compartment. Then gently press the other end of the pen into the compartment.

For removal, press in on either end of the pen. This will pop the opposite end of the pen out of the compartment. You can then remove the pen.

Kensington security slot

Allows easy attachment of a security cable.

Pen tether attachment points

If you will be using the pen tether, use the tether attachment ring and small thumb screw to connect it to one of four attachment points located on the back of the unit.

Stand adjustment lever

Pull this lever up to adjust the stand. Release the lever to lock the stand in place.

Video, USB, and power connectors

Stand

The stand can be used to adjust the tilt angle of the unit.

CAUTION Be careful to avoid catching your finger in the gap of the movable portion of the stand.

Important: Be sure to adjust the stand to the low tilt position before packaging the DTF-521/PL-521. If you do not close the stand, the notched mechanism may be damaged during transportation and storage. Do not lift the unit by the stand; this may damage the stand mechanism. When lifting or moving the pen display, always do so by grasping the main body casing.

Next step: Installation. See page 9.

Pen display components page 8