Wacom PL-521, DTF-521 manual Using an alternate mount or stand

DTF521_Manual.fm Page 41 Tuesday, February 28, 2006 10:36 AM

Using an alternate mount or stand

If you will be using the DTF-521/PL-521 pen display in an installation that requires the use of an alternate mounting platform, you can remove the adjustable stand from the unit and mount the pen display onto any mount arm or stand conforming to the VESA 75 standard.

Mounting screws that are 4 mm wide with a 0.7 mm pitch (M4 Regular), with a screw clearance depth of 15 mm are required. Exceeding the clearance depth of 15 mm will damage the pen display internal components.

To remove the adjustable stand and attach the pen display to a different mounting platform:

1. Turn off your computer and power off the DTF-521/PL-521. Then disconnect all cables from between the unit and your computer.

2.Protect the display screen surface by spreading a soft cloth onto a flat table and placing the pen display face down on the cloth.

3.Remove the four screws and lift the adjustable stand assembly away from the body of the unit.

4.Using the appropriate screws for your mounting platform, firmly attach the

pen display to the alternate mounting platform.

5.Refer to the Installation instructions, beginning on page 9, and reattach the

cabling.

CAUTION When attaching the DTF-521/PL-521 onto an alternate mounting platform, be sure to follow all instructions in the documentation supplied by the platform manufacturer. If improperly installed, the unit could fall, resulting in damage to the unit or physical injury.

Appendix page 41