6 F 3 B 0 3 5 6
TermSTS
TermSTS | Status | Meaning |
|
|
|
00H | Normal complete |
|
|
|
|
01H | Register designation error | • Occurs if a register other than XW, YW,W, LW, RW, D, F, T, C, or SW is |
|
| designated as the data storage register in one of the following requests. |
|
| Requests: Remote station loopback, Register read/write. |
|
| • In a register read or write request, the request designated a read or write from |
|
| a T register to a register other than a T register. |
|
| (This also applies to C registers.) |
|
|
|
02H | Response timeout | • Occurs if a response is not received within the designated time for a remote |
|
| station loopback or register read/write request. |
|
|
|
03H | Parameter error | • Occurs if a value other than 2 is designated for the module ID. |
|
| • Occurs if a value other than 1 (T2N/T3H) or 2 (T3H) is designated for the |
|
| channel number. |
04H | Register write protect | • Occurs if an attempt to write is made when the remote registers were write |
|
| protected. |
|
| • Occurs if an attempt to read is made when the local registers were write |
|
| protected. |
|
|
|
05H | (Reserved) |
|
|
|
|
06H | Module error | • Occurs if the module is down. |
|
|
|
|
| • Occurs if the master station of PC link times out |
|
|
|
| Initialization in progress | • Occurs if the module is initializing. |
|
|
|
07H | No send channel (CH) | • Occurs if the corresponding |
|
|
|
08H | Invalid station number | • Occurs if the local station address designated 0 or over 64. |
|
| • Occurs if the remote station address was set up the same local station |
|
| address. |
|
|
|
09H | Transfer size error | • Occurs if either 0 or 129 or more words were designated for either a register |
|
| read/write or a remote station loopback request. |
0AH | Boundary error | • Occurs if the specified area (start address + register range) does not exist in |
|
| the T2N/T3H data storage registers. |
|
| Requests: Remote port loopback, Register read/write |
|
|
|
0BH | Transmission error | • Occurs if the |
|
| Detailed information (the |
|
|
|
0CH | I/O no answer error | • Occurs if the T2N/T3H cannot access |
|
|
|
0DH | IC card designation error | • Occurs if an error occurs when the T3H IC card is being used as register |
| (T3H) | (expanded F register) in one of the following request. |
| (See the T3H Instruction Manual.) | |
|
| |
|
| Request: Register read/write |
|
| 1. Occurs if IC card is not setting up. |
|
| 2. IC card type error |
|
| 3. Register write protected |
|
|
|
| (Reserved : T2N) |
|
|
|
|
0EH | Retry timeout error | • Occurs if a T2N retransmission times out. |
|
|
|
0FH | (Reserved) |
|
|
|
|
⎯ 50 ⎯