Toshiba S20LP instruction manual RAS information monitored on S-LS

Page 39

6 F 3 B 0 3 5 6

5.5 RAS information monitored on S-LS

By connecting the S-LS, the following RAS information can be monitored.

(1)Online map

(Menu)

R:RAS Information

1:Online Map

The number (1-64) on the screen shows the Station number.

The operation mode displayed under the Station number means as follows. ¡(Blue) Online mode

¡(Red) Standby mode

Blank Offline mode or not existing

This information is read out from the S-LS connecting station every three seconds.

⎯ 38 ⎯

Image 39

Contents T2N/T3H stations Important Information Preface Contents Introduction to S20LP System configurationStation hardware ∙ OverviewT2N include of S20LP Port SN325 SN325∙ Status LEDs S20LP port for T2N PU245NFor SN325 ∙ Loader port ∙ Station number setting switches∙ Transmission cable connectors ∙ Reset switch only SN325Menu LS overview⎯ 10 ⎯ Specifications S20LP system specificationsS20LP-station specifications Scan transmission overview Allocation and network assignment by T-PDS Setting the data send block by S-LSSetting for data linkage Station number settingSettings on T-PDS Link PDS screen example Block Send Receive ⎯ 18 ⎯ Global ⎯ 20 ⎯ Settings on S-LS ⎯ 22 ⎯ ⎯ 23 ⎯ ⎯ 24 ⎯ ∙ Message Transmission ∙ Scan Access∙ Start with Standby mode ∙ Scan Transmission∙ Target Scan Time Data linkage example ∙ Settings on T-PDS Setting on S-LS LS setting screen 2 for STN #2 Cable connections ∙ Transmission cable breakage RAS functionBehavior in trouble ∙ Station downSelf-diagnostic function At initialization at power onDuring operation LED indication SN325T2N RAS information monitored in T2N/T3H Online map Station statusLoop map Only T2N Standby mapNumber 1-64 on the screen shows the Station number RAS information monitored on S-LSSelf Station Station No.01 Offline Select the Station Number Click the Status Display Station down information Possible error message are as followsFunction Instruction SpecificationExpanded data transfer instruction Instruction formatTransfer parameter table Parameter and construction∙ Operation Sample programRemarks PC link protocol Message transmissionMessage transmission Computer link protocol∙ Send CMD Transfer parameters aStatus B TermSTS Status Meaning Detailed Information Send completion status Transfer parameters PC link protocol transmission Data writeRID Important items Status See 7.3 5 for details on bits C, D, E, and FXW/YW PC link protocol transmission Data read ⎯ 57 ⎯ SW067 Write enabled Remarks PC link protocol transmission programLength END Scan cycle Appendix⎯ 63 ⎯ PDS remote programming PDS Setup options screen