Toshiba TDP-MT500 owner manual Preparation, Checking accessories

PREPARATION

Checking accessories

The following accessories are provided with this projector. Check to be sure that all the accessories are packed in the package.)

Power supply parts

Remote controller parts

Power cable Conversion adaptor

	Size-AAA
Remote controller	dry batteries (two)

Personal computer parts Video parts Others

D-SUB 9P

Mini DIN 8P

Mini D-SUB 15P

DVI

•Lens cap (Attached to the main body)

•Soft carrying case

•Operation manual

•Regular user card

•Warranty card

•Remote controller photo-sensor protection sticker

RS-232C cable

Mini D-SUB 15P DVI-conversion cable

•The attached power cable and conversion adaptor are to be used exclusively for this product. Never use them for other products.

Inserting the dry batteries into the remote controller

1	1. Remove the rear lid of the remote controller.
	2. Check the polarity (+), (-) of the dry batteries, and set
3	them correctly inserting their (-) side first.
	• If the battery is inserted from the (+) side first, inserting
	the (-) side is difficult because the coil spring end hits on
2	the battery side. If the battery is forced to insert in this
	way, the outer label of the battery may get ripped and it

may cause short-circuit and heating. 3. Attach the rear lid.

• Use two size-AAA dry batteries (RO3).

• Exchange the two batteries to new ones if the distance that allows the remote controller to operate becomes shorter than usual.

•Correctly treat the batteries after thoroughly reading "On treating the batteries" described on Page 7. If the batteries are treated incorrectly, they may cause fire or peripheral contamination due to leakage of the liquid, heating, or burst. (Read the cautions indicated on the battery, too.)

•This projector is designed as plug-in equipment. There must be an easily accessible power outlet near the installed projector.

•Use the attached power cord with this projector. Using any other power cord than specified could cause electromagnetic interference to radio or television broadcast.

•Use the attached mini D-SUB 15pin-DVI conversion cable and RS-232C cable to suppress the inter- ference within the restriction for J55022 class-B apparatus.

•Use a DVI shielded cable to suppress the interference within the restriction for J55022 class-B appa- ratus.

•Be sure to connect this projector to a ground.

11