Toshiba TDP-MT500 owner manual Indicators, Power Lamp Temp State, Remark

INDICATORS

How to see the internal states from indicators

There are three indicators that inform of the internal states of the projector. The internal states can be known by how the indicators are lighting. Check the followings, and if there is any problem, stop to use the projector and be sure to unplug the power plug. Then, contact a repair/customer front of Mitsubishi Electric Corporation.

POWER indicator

When the projector is normal:

MENU/EXIT ENTER

POWER

LAMP indicator

LAMP

TEMP

TEMP(temperature) indicator

POWER LAMP TEMP STATE REMARK

On in orange		Standby state.
Blinking in green		Lamp standby state.	Power can not be turned "OFF".
	Off Off
		Power "ON" (usually).
On in green
Blinking in orange		Lamp is being cleaned.	Power can not be turned "ON".

If the projector is not normal:

POWER LAMP TEMP			STATE
		The interior of the projector is very hot.
		•	The intake vent and/or exhaust vent is blocked
			with something.
On in	Off	On in red •	The projector is used at a very hot place such as
orange			outlet of heating air.
		•	The air filter is foul.
		The protection circuit is working, or
		The lamp is not normal.
		(When power is turned off normally, this indication appears,
		and this is not a failure.)
	On in red	Off
On in
green

REMARK

Countermeasure

•Remove those things with which the vent is blocked.

•Relocate the projector.

•Clean the filter.

•Press POWER button after POWER

indicator has ceased blinking.

If this operation is repeated several times and the light-source lamp still does not come on, replace the lamp to a new one. Ask the delivery agent of the projector or a repair/customer front of Mitsubishi Electric Corporation about purchase of the lamp.

			Indicating replacement of the lamp (Used about 1000
			hours* in total; Power is "ON".)
	Blinking
			Indicating replacement of the lamp (Used about 1000
	in red
		Off	hours* in total; Power is "OFF".)
On in
			Indicating replacement of the lamp (Used about 1500
orange On in red
			hours* in total)

Replace the light-source lamp to a new one. Purchase a light-source lamp from the delivery agent of the projector.

Kensington Lock

This projector has a Kensington Security Standard connector for use with a Kensington MicroSaver Security System. Refer to the information that came with the Kensington System for instructions on how to use it to secure the projector. Please contact to Kensington Technology Group as shown below.

Kensington Technology Group

2855 Campus Drive

San Mateo, CA 94403, U.S.A.

Phone : (650)572-2700 Fax : (650)572-9675

38