Connecting to the network, Installation method

E6581295⑥

4. Connecting to the network

4.1.Installation method

(1)Attach DeviceNet cable to DeviceNet connector. (Refer to Section 2.1). (Be careful not to short-circuit adjacent terminals on DeviceNet connector).

Thin branch cables: DeviceNet-specific thin cable. <Tightening torque>

0.5 - 0.6 N·m

Recommended screwdriver: Small flat-blade screwdriver (blade thickness: 0.6mm,

blade length: 3.5mm or less)

(2)Please set the terminating resistance if needed. <Terminating resistance specification>

1/4 W - 121 ohm, 1% Metal Film

(3)Using the DIP switch on the DeviceNet option, set a MAC ID number and a baud rate. (Refer to Section 4.3).

(4)Once all the parameters are set, the power must be cycled to the VF-AS1/PS1 for these changes to take effect. (Refer to Section 5.)

- 10 -