Siemens Panel PC 870 appendix Installation cut-out for Panel PC

Release 11/02 Unpacking and Installing the Panel PC 670/870

L5 ±0.2

*)

112 ±0.5

Drill hole for screw fixings

M6/∅7

A1 ±1

*)

L3 ±1	L3 ±1	112 ±0.5
S1 ±1	S2 ±1
		Pressure points
		for clamps
L2 +1	L1 +1	112 ±0.5 56 ±1
S1 ±1	S1 ±1

A2 ±1

Clamp with grub screws

Rz 120 (in gasket area)

Gasket area

L4 ±0.2

min. 1.5 – max. 6

Operating units	L1	L2	L3	L4	L5	A1	A2	S1	S2
(a) with key-based front panels:
10.4"-TFT / 12.1"-TFT	450	290	78	465	235	16	10	–	–
15.1"-TFT	450	321	51	465	279	16	17	–	–
(b) with touchscreen front panels:
12.1"-TFT	368	290	–	–	–	16	10	35	19 *) cut-outs only for 15" TFT
15.1"-TFT	450	290	81	465	235	16	10		(8HE)
								–	–

Figure 1–6 Installation cut-out for Panel PC

Refer to Figure 1–6 to check that the screws and pressure points on the rear side, and the shaded seal area are freely accessible after completion of the installation cut-out.

Otherwise, it is possible that the installation cut-out cannot be used.

When the conditions mentioned are fulfilled, complete the installation cut-out according to the next step.

SIMATIC Panel PC 670/870 Start-Up Instructions 1–7