Siemens manual Server Setup, Bus scan, ISP configuration

Page 30

Server Setup

Bus scan

Under this menu item all bus users connected are located automatically, and the corresponding results are displayed. Click “Start Scan” to initiate the “Bus scan”.

After the message “Scanning done” appears, the ChemWeb Server reinitializes all aspects of the traced devices. This may take up to 1 minute.

This window also states the software version and the software date of the ChemWeb Server below the scan results.

ISP configuration

Under this menu item, the ChemWeb Server is supplied with the data from your provider for access to Internet. Type the data you received from your provider in the corresponding boxes and confirm the entry by clicking “Send”.

Parameter

This entry box contains the dial data for seizing an exchange line in the case of telephone systems (0, etc., refer to the operating instructions of the telephone system). Generally, a ring back tone is not waited for!

24

Image 30
Contents ChemWeb Server Page Table of Contents Software and Firmware License Disconnect and Lockout Power Before Servicing Page Overview of ChemWeb Server Power Supply Description of ChemWeb ServerExt. Reset Inputs IN1, IN2COM 0 W&T RS485 bus W&T RS232 Telephone line only for analog or Isdn version COM 1 RS232 null modemEthernet / 10BaseT RJ45 OutputsCompactFlash slot CF LED displaysConnecting more than one ChemWeb Server Installation of RS485 busRS485 bus system 390 Ohm +/- 2 % Setting the IP address of the ChemWeb Server Network connection in a LANDirect network connection Setting the IP address of the ChemWeb Server Switched connection via modem Analog modem Isdn modemSetting the IP address of the ChemWeb Server Setting the IP address of the ChemWeb Server Setting the IP address of the ChemWeb Server Null modem connection via serial interface Setting the IP address of the ChemWeb Server Setting the IP address of the ChemWeb Server Setting the IP address of the ChemWeb Server Setting the IP address of the ChemWeb Server Setting the IP address of the ChemWeb Server Setting the IP address of the ChemWeb Server Setting the IP address of the ChemWeb Server without Dhcp Setting the IP address of the ChemWeb Server with Dhcp Connection via InternetBasic settings via a Browser StartupServer Setup ISP configurationBus scan Mail configuration Event configuration Time/date setting Server commandsChange passwords Name configuration Chip info Operation via Web Browser Operation and Data AccessDisplay and configuration window Navigation windowOperation and Data Access 03 04 a 00.TXT Log filesData access via FTP Backing up log filesData access to CompactFlash card with card scanner Data access via Web BrowserTechnical data Appendix Tested Web Browser Appendix Appendix Page Siemens All Rights Reserved