Siemens manual Time/date setting, Server commands

Server Setup

The entry box “Release value” specifies the value at which the event initiates the information e-mail.

By clicking the selection box under “Activate”, the event is enabled.

The entries are stored by clicking “send data”. By clicking “close window”, the window is closed without storing the entries.

If a connection to the Internet cannot be established after an event has occurred, the ChemWeb Server will try it again every 5 minutes.

An e-mail due to an event is only released within a time frame of 5 minutes. Events which occur earlier are deleted and cannot be recorded!

Time/date setting

Under this menu item, the internal clock of the ChemWeb Server can be set. The data can be entered manually or be imported from the PC clock by clicking “Fields sync to PC clock”. To confirm the entry for the internal clock of the ChemWeb Server, click “Set webserver clock”.

If the power supply of the ChemWeb Server is switched off for more than 2 days, the date and time setting must be checked after restart and corrected if necessary!

Server commands

Connect ISP / Disconnect ISP:

Click this command to connect the ChemWeb Server manually to the Internet by using the data from “ISP Configuration”. As soon as the connection has been established, the ChemWeb Server creates an e-mail with the valid IP address which is sent to the receiver addresses set under “Mail Configuration”. The ChemWeb Server can then be reached in the Internet via an assigned IP address.

27