Toshiba BSA4TMTS12QMR, BSA4TMGS12QMR manual Operation Panel For the B-SA4TP

Page 22

3.MAIN UNIT REPLACEMENT

EO18-33016A

3.8 Operation Panel (For the B-SA4TP)

3.8 Operation Panel (For the B-SA4TP)

1. Open the Ribbon Cover.

Ribbon Cover

Ribbon Cover

2.Remove the two screws and release the two hooks to detach the Operation Panel from the Ribbon Cover.

FLT-3x12 Screw

Hook

Hook

Operation Panel

3. As shown in the picture below, unhook the Operation Panel Cover.

Ribbon Cover

Hook

Operation Panel

4.Disconnect the Operation Panel Cable from CN1 on the Panel PC Board.

5.Remove the four screws to detach the Panel PC Board.

Operation Panel Cable

PT-3x8 Screw

Panel PC Board

CN1

3-18

Image 22

Contents SA4T Series Table of Contents Procedure UnpackingPrinter Installation Main Unit Replacement PS UnitDraw out the PS PC Board Unit from the printer Main PC Board Ass’y SA4TM SA4TPCable Protection Cover CN9 CN6 Be careful not to pinch the lead wires by the Side Panel Platen Stepping Motor and Top Cover Open Sensor Left Do not remove, just loosen Adjustment of Timing Belt Ribbon Motor/Ribbon Sensor Remove the screw to detach the Ribbon Motor Unit Remove the screws to detach the Ribbon Motors FLT-3x8 Screw Locating Pin Fan Motor Operation Panel For the B-SA4TM Remove the two screws to detach the LCD PC board Operation Panel For the B-SA4TP Panel PC Board LCD PC Board Print Head Never loosen or remove these screwsDisconnect the Print Head Cable from the Print Head Disconnect the Print Head Cable from the Print Head Media Sensor Ring Remove the Lower Sensor Cover Top by releasing the two hooks Sensor Harnesses Media Sensor Top Cover Open Sensor Right Remove the two screws from the Stepping Motor Unit Disconnect the Top Cover Open Sensor Harness Blue Periodic Maintenance Procedure Cutter Unit Set Screw Same way, clean the outside of the cutter blade Apply Floil G-488 to the cutter unit using a soft cloth Troubleshooting Printer does not turn onHead Open is displayed Eeprom Error is displayedSome printers show on Line and others show in Line Printer cannot enter the download mode Printer cannot enter the system modeHead Temp is displayed when printing is attempted Head temperature may be higher Troubleshooting Ribbon Error is displayed Characters cannot be printedRibbon is not taken up „ Situation Communication

Related manuals

Manual 132 pages 33.17 Kb

Manual 113 pages 21.72 Kb