Toshiba BSA4TMGS12QMR, BSA4TMTS12QMR manual Main PC Board Ass’y, SA4TM SA4TP

Page 7

3.MAIN UNIT REPLACEMENT

EO18-33016A

3.2 MAIN PC Board Ass’y

3.2 MAIN PC Board Ass’y

1. Remove the two screws from the back of the printer.

SMW-3x6 Screw

SMW-3x8* Screw

[B-SA4TM]

[B-SA4TP]

2.Only for the B-SA4TM model, open the Front Cover, and remove the two screws that secure the Front Cover.

Front Cover

SMW-3x6 Screw

3.Close the Front Cover.

4.Slightly open the Top Cover, and remove the Side Panel.

Top Cover

Side Panel

Top Cover

Side Panel

Hook

[B-SA4TM]

[B-SA4TP]

5. Close the Top Cover.

3- 3

Image 7

Contents SA4T Series Table of Contents Unpacking Procedure Printer Installation PS Unit Main Unit ReplacementDraw out the PS PC Board Unit from the printer SA4TM SA4TP Main PC Board Ass’yCable Protection Cover CN9 CN6 Be careful not to pinch the lead wires by the Side Panel Platen Stepping Motor and Top Cover Open Sensor Left Do not remove, just loosen Adjustment of Timing Belt Ribbon Motor/Ribbon Sensor Remove the screw to detach the Ribbon Motor Unit Remove the screws to detach the Ribbon Motors FLT-3x8 Screw Locating Pin Fan Motor Operation Panel For the B-SA4TM Remove the two screws to detach the LCD PC board Operation Panel For the B-SA4TP Panel PC Board LCD PC Board Never loosen or remove these screws Print HeadDisconnect the Print Head Cable from the Print Head Disconnect the Print Head Cable from the Print Head Media Sensor Ring Remove the Lower Sensor Cover Top by releasing the two hooks Sensor Harnesses Media Sensor Top Cover Open Sensor Right Remove the two screws from the Stepping Motor Unit Disconnect the Top Cover Open Sensor Harness Blue Periodic Maintenance Procedure Cutter Unit Set Screw Same way, clean the outside of the cutter blade Apply Floil G-488 to the cutter unit using a soft cloth Printer does not turn on TroubleshootingHead Open is displayed Eeprom Error is displayedSome printers show on Line and others show in Line Printer cannot enter the download mode Printer cannot enter the system modeHead Temp is displayed when printing is attempted Head temperature may be higher Troubleshooting Characters cannot be printed Ribbon Error is displayedRibbon is not taken up „ Situation Communication

Related manuals

Manual 132 pages 33.17 Kb

Manual 113 pages 21.72 Kb