Toshiba BSA4TMTS12QMR, BSA4TMGS12QMR manual Cable Protection Cover

Page 8

3.MAIN UNIT REPLACEMENT

EO18-33016A

3.2 MAIN PC Board Ass’y

6.Remove the screw to detach the Cable Clamp fixing the Print Head Cable (white).

7.Disconnect the all cables from the MAIN PC Board ass’y.

NOTE: Be careful that the connector of the Power Cable has a connector lock.

Cable Clamp

Print Head Cable

(White)

SMW-3x8 Screw

Power Cable

Connector Lock

8.To easily remove the MAIN PC board from the B-SA4TM model, remove the cable protection cover by squeezing and raising it.

Cable Protection

Cover

9.Remove the two screws from the printer back. Also, remove the screw which secures the MAIN PC board together with the ground wires (orange and red lead wires).

10.Remove the MAIN PC board Ass’y from the printer.

NOTE: Be careful not to hit the component parts on the MAIN PC board against the printer frame.

		Red Lead Wire
	P-3x6 Screw
	and Toothed	Orange Lead Wire
	Washer	Orange Lead Wire
	Washer

SMW-3x6 Screw

3- 4

Image 8

Contents SA4T Series Table of Contents Procedure UnpackingPrinter Installation Main Unit Replacement PS UnitDraw out the PS PC Board Unit from the printer Main PC Board Ass’y SA4TM SA4TPCable Protection Cover CN9 CN6 Be careful not to pinch the lead wires by the Side Panel Platen Stepping Motor and Top Cover Open Sensor Left Do not remove, just loosen Adjustment of Timing Belt Ribbon Motor/Ribbon Sensor Remove the screw to detach the Ribbon Motor Unit Remove the screws to detach the Ribbon Motors FLT-3x8 Screw Locating Pin Fan Motor Operation Panel For the B-SA4TM Remove the two screws to detach the LCD PC board Operation Panel For the B-SA4TP Panel PC Board LCD PC Board Print Head Never loosen or remove these screwsDisconnect the Print Head Cable from the Print Head Disconnect the Print Head Cable from the Print Head Media Sensor Ring Remove the Lower Sensor Cover Top by releasing the two hooks Sensor Harnesses Media Sensor Top Cover Open Sensor Right Remove the two screws from the Stepping Motor Unit Disconnect the Top Cover Open Sensor Harness Blue Periodic Maintenance Procedure Cutter Unit Set Screw Same way, clean the outside of the cutter blade Apply Floil G-488 to the cutter unit using a soft cloth Troubleshooting Printer does not turn onSome printers show on Line and others show in Line Eeprom Error is displayedHead Open is displayed Head Temp is displayed when printing is attempted Printer cannot enter the system modePrinter cannot enter the download mode Head temperature may be higher Troubleshooting Ribbon Error is displayed Characters cannot be printedRibbon is not taken up „ Situation Communication

Related manuals

Manual 132 pages 33.17 Kb

Manual 113 pages 21.72 Kb