Auto

[X-coordinate]:

Set a fine adjustment value to offset the print position perpendicular to the paper feed direction in units of 0.1 mm.

When the value is negative (-), the upper right reference coordinate shifts to the left from the zero point.

Default	0.0 mm
Range	-99.5 to +99.5 mm

[Tone Adjustment] Group [Thermal Transfer]:

Set a fine adjustment value for print density in thermal transfer print mode.

The fine adjustment value set by the Print Density Fine Adjust command [AY] is displayed in the left box. When the parameter is not retrieved, the value in the left box becomes zero (0).

Default	0
Range	-20 to +10

[Direct Thermal]:

Set a fine adjustment value for print density in direct thermal print mode.

The fine adjustment value set by the Print Density Fine Adjust command [AY] is displayed in the left box. When the parameter is not retrieved, the value in the left box becomes zero (0).

Default	0
Range	-20 to +10

[Command] Group

[Control Code]:

Select a control code used for command analysis.

Default	AUTO
Options	AUTO, [ESC] [LF] [NUL], { }, Manual

[Code 1]:

When "Manual" is selected for the [Control Code], set a code for the first byte in hex. format. Enter two alphanumeric characters from "0" to "F".

Entries are not case-sensitive.

Two characters indicate one HEX character. (Example: "0" -> "30" or "A" -> "41")

Default	1B
Range	20 to FF

[Code 2]:

When "Manual" is selected for the [Control Code], set a code for the second byte in hex. format. Enter two alphanumeric characters from "0" to "F".

Entries are not case-sensitive.

Two characters indicate one HEX character. (Example: "0" -> "30" or "A" -> "41")

Default	0A
Range	20 to FF

[Code 3]:

When "Manual" is selected for the [Control Code], set a code for the third byte in hex. format. Enter two alphanumeric characters from "0" to "F".

Entries are not case-sensitive.

Two characters indicate one HEX character. (Example: "0" -> "30" or "A" -> "41")

Default	00
Range	20 to FF

[BASIC] Group

[Basic Interpreter]:

Select whether or not the basic interpreter is enabled.

Default	Disable
Options	Disable, Enable

[Basic Trace]:

Select whether or not the basic trace is enabled.

Default	Disable
Options	Disable, Enable