1 | SATA hard drive power cable | 2 | fan cable |
|
|
|
|
|
|
3 | cable retaining clip | 4 | SATA data cable |
|
|
|
|
|
|
5 | bracket screw | 6 | captive screws (2) |
|
|
|
|
|
|
|
|
|
|
|
Removing the Hard Drive
1.Perform the procedure in Before Working on Your Computer.
2.Remove the hard drive bracket assembly (see Removing the Hard Drive Bracket Assembly).
3.Disconnect the SATA data/power cable from the hard drive.
4.Remove the four screws that secure the hard drive to the hard drive bracket assembly.
1 | screws (4) | 2 | hard drive connector |
|
|
|
|
3 | rubber grommets (4) | 4 | hard drive bracket assembly |
|
|
|
|
5. Lift the hard drive out of the assembly.
Replacing the Hard Drive
NOTE: Replacement hard drive kits may be shipped with rubber grommets. These grommets must be replaced if any are damaged or missing from the hard drive bracket assembly.
1.Replace all rubber grommets on the hard drive bracket that are damaged or missing.
2.Place the hard drive in the carrier with the label facing up and the cable connectors toward the open end of the bracket.
3.Secure the hard drive to the bracket assembly, affixing the four screws through the rubber grommets.
4.Connect the SATA data/power cable to the hard drive.