Note the routing of the DC power cables underneath the tabs in the chassis as you remove them from the system board and drives. It is important to route these cables properly when you replace them to prevent them from being pinched or crimped.
3.Remove the screw below the fan guard on the back of the chassis.
4.Slide the power supply toward the front of the computer approximately 1 inch.
5.Lift the power supply up and out of the chassis.
Expansion-Card Cage
Figure 14. Expansion-Card Cage Removal
1Securing lever
2
3Slots (2)
4Tabs (2)
To remove the
1.Examine any cables connected to expansion cards through the
NOTICE: Use a wrist grounding strap as explained in "Precautionary Measures."
2.Locate the securing lever (see Figure 14). Rotate the lever upward until it stops in an upright position.
3.Slide the
4.Lift the
To replace the
1.With the securing lever in the upright position, align the
2.Rotate the securing lever downward until it is flush with the top of the chassis. Make sure that the riser board is fully seated in the RISER connector on the system board.
3.Reconnect any cables you removed in step 1 of the previous procedure.
Riser Boards
The