
Control Panel
Figure 7. Control Panel Removal
1Control panel
2Chassis intrusion switch
To remove the control panel in the
1.Disconnect the control panel cable from the PANEL connector on the system board (see "System Board Labels" for the location of the PANEL connector).
2.From inside the chassis, remove the mounting screw that secures the control panel to the chassis.
3.Disconnect the chassis intrusion switch cable connector from the control panel.
4.Remove the control panel from the chassis.
When you reinstall the control panel, be sure to put the right side of the control panel behind the mounting tab.
Chassis Intrusion Switch
Figure 8. Chassis Intrusion Switch Removal
1Control panel
2Chassis intrusion switch
To remove the chassis intrusion switch in the
1.Disconnect the chassis intrusion switch cable connector from the control panel on the front of the chassis as shown in Figure 8. Note the routing of the chassis intrusion cable as you remove it from the chassis. Hooks on the chassis keep the cable in place.
2.Slide the chassis intrusion switch out of its slot to remove it from the chassis (see Figure 8).
3.Install the replacement chassis intrusion switch and cable.