1Battery
2Socket
CAUTION: There is a danger of the new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer’s instructions.
To remove the system battery, perform the following steps:
1.If possible, enter System Setup and print the System Setup screens.
2.Rotate the power supply up until it locks (see Figure 20).
3.Remove the system battery by carefully prying it out of its socket with your fingers or with a blunt, nonconducting object, such as a plastic screwdriver.
When you replace the system battery, orient the new battery with the "+" facing up. Insert the battery into its socket and snap it into place.
System Board
Figure 36. System Board Removal
1System board
2Screw
To remove the system board, perform the following steps:
1.Place the computer on its side on a flat surface.
2.Disconnect all cables from their connectors at the back of the computer.
3.Remove the
4.Unlatch and rotate the power supply until it locks (see Figure 20).
5.Remove the airflow shroud from the microprocessor.
6.Disconnect all cables from the system board.
7.Remove the screw that secures the system board to the bottom of the chassis.
8.Slide the system board toward the front of the chassis until it stops.
9.Carefully lift the system board out of the chassis (be sure to lift evenly and not twist the system board). To replace the system board, perform the following steps: