1Padlock ring
2Securing buttons (2)
To remove the computer cover, perform the following steps:
1.Press in to retract the padlock ring into the cover to open (see Figure 3).
2.Press in on the two securing buttons until the cover is free to swing up (see Figure 3).
3.Raise the back of the cover, and pivot it toward the front of the computer.
4.Lift the cover off the hooks at the front of the chassis.
5.Disengage the tabs that secure the cover to the top of the chassis, and lift the cover away.
Figure 4. Computer Cover Replacement
To replace the computer cover, perform the following steps:
1.Face the front of the computer and hold the cover at a slight angle (see Figure 4).
2.Align the bottom of the cover with the bottom of the chassis and insert the hooks on the cover into the recessed slots on the computer chassis so that the tabs catch the hooks inside the slots.
3.Pivot the cover down toward the back of the chassis and into position. Make sure that the securing buttons click into place.
4.If you wish to install a padlock, slide the padlock ring out of the cover.
To reset the chassis intrusion detector, perform the following steps:
1.Reconnect all cables to their connectors at the back of the computer.
2.Restart the system.
3.Enter System Setup. To do this, press <F2> when F2=Setup appears in the
If the operating system begins to load into memory, allow the system to complete the load operation, shut down the system, and try again.
4.Restore the system configuration settings.