1Power cable
2EIDE interface cable
3IDE1 connector on system board
NOTICE: You must attach the blue connector on the EIDE interface cable to the IDE1 connector on the system board to avoid possible damage to your system.
10.If it is not already connected, connect the blue connector on the EIDE interface cable to the IDE1 connector on the system board. To locate the IDE1 connector on the system board, see "System Board Components."
11.Replace the computer cover.
12.Reset the chassis intrusion detector. While in System Setup, update the appropriate Primary Drive option, 0 or 1 (see the online System User's Guide for complete information).
13.Partition and logically format your drive before you proceed to the next step. See the documentation for your operating system for instructions.
14.If the drive you just installed is the primary drive, install your operating system on the
System Power Supply
Figure 13. Power Supply Removal
1AC power cord
2AC power receptacle
3Power supply
4DC power cables
5Securing screw
To remove the system power supply, perform the following steps:
1.Disconnect the AC power cable from the back of the power supply.
2.Disconnect the DC power cables from the system board and the drives.