The Boot Device Menu appears, listing all available boot devices. Each device has a number next to it.
3At the bottom of the menu, enter the number of the device that is to be used for the current boot only.
Changing Boot Sequence for Future Boots
1Enter system setup (see page 82).
2Use the arrow keys to highlight the Boot Sequence menu option and press <Enter> to access the
NOTE: Write down your current boot sequence in case you want to restore it.
3Press the up- and
4Press the spacebar to enable or disable a device (enabled devices have a checkmark).
5Press plus (+) or minus
Clearing Forgotten Passwords
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
1Shut down the computer through the Start menu (see page 18).
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.
2Turn off any attached devices and disconnect them from their electrical outlets.
3Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4Remove the computer cover (see page 55).
5Locate the
When you receive your computer, the jumper is attached to only one pin.
6Replace the computer cover (see page 78).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
7Connect your computer and devices to electrical outlets, and then turn them on.
8If you are prompted to press <F1> to continue, press <F1>.
Appendix
85