D-Link DIR-68 manual Configuration

Page 20

Section 3 - Configuration

If you selected Dynamic, you may need to enter the MAC address of the computer that was last connected directly to your modem. If you are currently using that computer, click Clone Your PC’s MAC Address and then click Next to continue.

The Host Name is optional but may be required by some ISPs. The default host name is the device name of the Router and may be changed.

If you selected PPPoE, enter your PPPoE username and password. Click Next to continue.

Select Static if your ISP assigned you the IP address, subnet mask, gateway, and DNS server addresses.

Note: Make sure to remove your PPPoE software from your computer. The software is no longer needed and will not work through a router.

If you selected PPTP, enter your PPTP username and password. Click Next to continue.

D-Link DIR-628 User Manual

20

Image 20

Contents Page Trademarks PrefaceManual Revisions Table of Contents Wireless Security Troubleshooting Wireless BasicsTechnical Specifications Networking BasicsProductPackageOverviewContents System Requirements Browser RequirementsIntroduction Total PerformanceFeatures Hardware Overview ConnectionsLEDs WCN LEDInstallation Before you BeginWireless Installation Considerations Connect to Cable/DSL/Satellite Modem Turn on your computerConnect to Another Router Installation Getting Started Configuration Web-based Configuration UtilitySetup Wizard Click Internet Connection Setup Wizard to beginConfiguration Configuration Configuration Manual Configuration Dynamic CableInternet Setup ConnectionPptp Page L2TP Page Static assigned by ISP Wireless Settings Mode 2.4GHzChannel Scan Network Settings IP Address Subnet Mask Device NameDhcp Server Settings Type Secondary Wins IP AddressDhcp Reservation ClientsPage Virtual Server Configuration Port Forwarding Application Rules Enable Traffic Traffic Shaping QoS EngineClassification Network Filters Access Control Access Control Wizard Access Control Wizard Website Filters Add Website Select Allow or Deny Filtering RuleInbound Filters Firewall Settings Application Level Gateway Configuration Routing Advanced Wireless Settings Wi-Fi Protected Setup DefaultDevice Wizard Inbound Filter Advanced Network SettingsUPnP Administrator Settings Time Settings SysLog Check this box to send the router logs to a SysLog ServerEmail Settings Enable Email Notification From Email AddressAccount Name Password On Log Full On Schedule Smtp Server AddressSystem Settings File name for the settingsUpdate Firmware Ddns System Check Schedules Device Information Save Log Apply Log Settings RefreshLog Stats Internet Sessions Page Wireless Support Wireless Security What is WPA?Wireless Security Setup Wizard Launch Wireless Security Setup WizardIf you selected Manually, the following screen will appear Add Wireless Device with WPS Wizard Configure WPA-Personal PSK Configure WPA-Enterprise Radius Security Connect to a Wireless Network Using Windows VistaConfigure Wireless Security Security Connect Using WCN 2.0 in Windows Vista Using Windows XP Configure WPA-PSK Connecting to a Wireless Network Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics Wireless Local Area Network Wlan Wireless Personal Area Network WpanHome Small Office and Home OfficeSecurity Centralize your router or Access PointEliminate Interference Wireless Modes Networking Basics Check your IP addressStep Step Highlight Internet Protocol TCP/IP and click PropertiesTechnical Specifications Wireless Signal Rates1 Ieee 802.11n draft 2.0 HT20/HT40FCC Caution CE Mark WarningFCC Statement IC statement IC Radiation Exposure Statement