D-Link DIR-68 manual Port Forwarding

Page 38

Section 3 - Configuration

Port Forwarding

This will allow you to open a single port or a range of ports.

Name: Enter a name for the rule or select an application from the drop-down menu. Select an application and click << to populate the fields.

IP Address: Enter the IP address of the computer on your local network that you want to allow the incoming service to. If your computer is receiving an IP address automatically from the router (DHCP), you computer will be listed in the “Computer Name” drop-down menu. Select your computer and click <<.

TCP/UDP: Enter the TCP and/or UDP port or ports that you want to open. You can enter a single port or a range of ports. Seperate ports with a common.

Example: 24,1009,3000-4000

Inbound Filter: Select Allow All (most common) or a created Inbound filter. You may create your own inbound filters in the Advanced > Inbound Filter page.

Schedule: The schedule of time when the Virtual Server Rule will be enabled. The schedule may be set to Always, which will allow the particular service to always be enabled. You can create your own times in the Tools > Schedules section.

D-Link DIR-628 User Manual

38

Image 38
Contents Page Trademarks PrefaceManual Revisions Table of Contents Technical Specifications Wireless SecurityTroubleshooting Wireless Basics Networking BasicsProductPackageOverviewContents System Requirements Browser RequirementsIntroduction Total PerformanceFeatures Hardware Overview ConnectionsLEDs WCN LEDInstallation Before you BeginWireless Installation Considerations Connect to Cable/DSL/Satellite Modem Turn on your computerConnect to Another Router Installation Getting Started Configuration Web-based Configuration UtilitySetup Wizard Click Internet Connection Setup Wizard to beginConfiguration Configuration Configuration Manual Configuration Dynamic CableInternet Setup ConnectionPptp Page L2TP Page Static assigned by ISP Wireless Settings Mode 2.4GHzChannel Scan Network Settings IP Address Subnet Mask Device NameDhcp Server Settings Type Secondary Wins IP AddressDhcp Reservation ClientsPage Virtual Server Configuration Port Forwarding Application Rules Enable Traffic Traffic Shaping QoS EngineClassification Network Filters Access Control Access Control Wizard Access Control Wizard Website Filters Add Website Select Allow or Deny Filtering RuleInbound Filters Firewall Settings Application Level Gateway Configuration Routing Advanced Wireless Settings Wi-Fi Protected Setup DefaultDevice Wizard Inbound Filter Advanced Network SettingsUPnP Administrator Settings Time Settings SysLog Check this box to send the router logs to a SysLog ServerAccount Name Password On Log Full On Schedule Email SettingsEnable Email Notification From Email Address Smtp Server AddressSystem Settings File name for the settingsUpdate Firmware Ddns System Check Schedules Device Information Save Log Apply Log Settings RefreshLog Stats Internet Sessions Page Wireless Support Wireless Security What is WPA?Wireless Security Setup Wizard Launch Wireless Security Setup WizardIf you selected Manually, the following screen will appear Add Wireless Device with WPS Wizard Configure WPA-Personal PSK Configure WPA-Enterprise Radius Security Connect to a Wireless Network Using Windows VistaConfigure Wireless Security Security Connect Using WCN 2.0 in Windows Vista Using Windows XP Configure WPA-PSK Connecting to a Wireless Network Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics Wireless Local Area Network Wlan Wireless Personal Area Network WpanHome Small Office and Home OfficeSecurity Centralize your router or Access PointEliminate Interference Wireless Modes Networking Basics Check your IP addressStep Step Highlight Internet Protocol TCP/IP and click PropertiesTechnical Specifications Wireless Signal Rates1 Ieee 802.11n draft 2.0 HT20/HT40FCC Caution CE Mark WarningFCC Statement IC statement IC Radiation Exposure Statement