D-Link DIR-68 manual Configure WPA-Enterprise Radius

Page 76

Section 4 - Security

Configure WPA-Enterprise (RADIUS)

It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the added overhead.

1.Log into the web-based configuration by opening a web browser and entering the IP address of the router (192.168.0.1). Click on Setup and then click Wireless Settings on the left side.

2.Next to Security Mode, select WPA-Enterprise.

3.Next to WPA Mode, select Auto, WPA2 Only, or WPA Only. Use Auto if you have wireless clients using both WPA and WPA2.

4.Next to Cypher Type, select TKIP and AES, TKIP, or AES.

5.Next to Group Key Update Interval, enter the amount of time before the group key used for broadcast and multicast data is changed (3600 is default).

6.Next to Authentication Timeout, enter the amount of time before a client is required to re-authenticate (60 minutes is default).

7.Next to RADIUS Server IP Address enter the IP Address of your RADIUS server.

D-Link DIR-628 User Manual

76

Image 76
Contents Page Manual Revisions PrefaceTrademarks Table of Contents Wireless Security Troubleshooting Wireless BasicsTechnical Specifications Networking BasicsProductPackageOverviewContents System Requirements Browser RequirementsIntroduction Total PerformanceFeatures Hardware Overview ConnectionsLEDs WCN LEDInstallation Before you BeginWireless Installation Considerations Connect to Cable/DSL/Satellite Modem Turn on your computerConnect to Another Router Installation Getting Started Configuration Web-based Configuration UtilitySetup Wizard Click Internet Connection Setup Wizard to beginConfiguration Configuration Configuration Manual Configuration Dynamic CableInternet Setup ConnectionPptp Page L2TP Page Static assigned by ISP Wireless Settings Mode 2.4GHzChannel Scan Network Settings IP Address Subnet Mask Device NameDhcp Server Settings Type Secondary Wins IP AddressDhcp Reservation ClientsPage Virtual Server Configuration Port Forwarding Application Rules Enable Traffic Traffic Shaping QoS EngineClassification Network Filters Access Control Access Control Wizard Access Control Wizard Website Filters Add Website Select Allow or Deny Filtering RuleInbound Filters Firewall Settings Application Level Gateway Configuration Routing Advanced Wireless Settings Wi-Fi Protected Setup DefaultDevice Wizard UPnP Advanced Network SettingsInbound Filter Administrator Settings Time Settings SysLog Check this box to send the router logs to a SysLog ServerEmail Settings Enable Email Notification From Email AddressAccount Name Password On Log Full On Schedule Smtp Server AddressSystem Settings File name for the settingsUpdate Firmware Ddns System Check Schedules Device Information Log Apply Log Settings RefreshSave Log Stats Internet Sessions Page Wireless Support Wireless Security What is WPA?Wireless Security Setup Wizard Launch Wireless Security Setup WizardIf you selected Manually, the following screen will appear Add Wireless Device with WPS Wizard Configure WPA-Personal PSK Configure WPA-Enterprise Radius Security Connect to a Wireless Network Using Windows VistaConfigure Wireless Security Security Connect Using WCN 2.0 in Windows Vista Using Windows XP Configure WPA-PSK Connecting to a Wireless Network Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics Wireless Local Area Network Wlan Wireless Personal Area Network WpanHome Small Office and Home OfficeEliminate Interference Centralize your router or Access PointSecurity Wireless Modes Networking Basics Check your IP addressStep Step Highlight Internet Protocol TCP/IP and click PropertiesTechnical Specifications Wireless Signal Rates1 Ieee 802.11n draft 2.0 HT20/HT40FCC Statement CE Mark WarningFCC Caution IC statement IC Radiation Exposure Statement