D-Link DIR-68 manual

Page 35

Section 3 - Configuration

Note: The Revoke option will not disconnect a PC with a current network session from the network; you would need to use MAC Address Filter to do that. Revoke will only free up a DHCP Address for the very next requester. If the previous owner is still available, those two devices may both receive an IP Address Conflict error, or the second device may still not receive an IP Address; in that case, you may still need to extend the “DHCP IP Address Range” to address the issue, it is located in the DHCP Server section.

Reserve: The Reserve option converts this dynamic IP allocation into a DHCP Reservation and adds the corresponding entry to the DHCP Reservations List.

D-Link DIR-628 User Manual

35

Image 35
Contents Page Trademarks PrefaceManual Revisions Table of Contents Networking Basics Wireless SecurityTroubleshooting Wireless Basics Technical SpecificationsProductPackageOverviewContents Browser Requirements System RequirementsTotal Performance IntroductionFeatures Connections Hardware OverviewWCN LED LEDsBefore you Begin InstallationWireless Installation Considerations Turn on your computer Connect to Cable/DSL/Satellite ModemConnect to Another Router Installation Getting Started Web-based Configuration Utility ConfigurationClick Internet Connection Setup Wizard to begin Setup WizardConfiguration Configuration Configuration Dynamic Cable Manual ConfigurationConnection Internet SetupPptp Page L2TP Page Static assigned by ISP Mode 2.4GHz Wireless SettingsChannel Scan IP Address Subnet Mask Device Name Network SettingsDhcp Server Settings Secondary Wins IP Address TypeClients Dhcp ReservationPage Virtual Server Configuration Port Forwarding Application Rules QoS Engine Enable Traffic Traffic ShapingClassification Network Filters Access Control Access Control Wizard Access Control Wizard Add Website Select Allow or Deny Filtering Rule Website FiltersInbound Filters Firewall Settings Application Level Gateway Configuration Routing Advanced Wireless Settings Default Wi-Fi Protected SetupDevice Wizard Inbound Filter Advanced Network SettingsUPnP Administrator Settings Time Settings Check this box to send the router logs to a SysLog Server SysLogSmtp Server Address Email SettingsEnable Email Notification From Email Address Account Name Password On Log Full On ScheduleFile name for the settings System SettingsUpdate Firmware Ddns System Check Schedules Device Information Save Log Apply Log Settings RefreshLog Stats Internet Sessions Page Wireless Support What is WPA? Wireless SecurityLaunch Wireless Security Setup Wizard Wireless Security Setup WizardIf you selected Manually, the following screen will appear Add Wireless Device with WPS Wizard Configure WPA-Personal PSK Configure WPA-Enterprise Radius Security Using Windows Vista Connect to a Wireless NetworkConfigure Wireless Security Security Connect Using WCN 2.0 in Windows Vista Using Windows XP Configure WPA-PSK Connecting to a Wireless Network Why can’t I access the web-based configuration utility? TroubleshootingWhat can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics Wireless Personal Area Network Wpan Wireless Local Area Network WlanSmall Office and Home Office HomeSecurity Centralize your router or Access PointEliminate Interference Wireless Modes Check your IP address Networking BasicsStep Highlight Internet Protocol TCP/IP and click Properties StepWireless Signal Rates1 Ieee 802.11n draft 2.0 HT20/HT40 Technical SpecificationsFCC Caution CE Mark WarningFCC Statement IC Radiation Exposure Statement IC statement