D-Link DIR-68 manual System Settings, File name for the settings

Page 59

Section 3 - Configuration

System Settings

Save Settings to Use this option to save the current router configuration Local Hard Drive: settings to a file on the hard disk of the computer you are using. First, click the Save button. You will then see a file dialog, where you can select a location and

file name for the settings.

Load Settings Use this option to load previously saved router from Local Hard configuration settings. First, use the Browse control Drive: to find a previously save file of configuration settings.

Then, click the Load button to transfer those settings to the router.

Restore to Factory This option will restore all configuration settings Default Settings: back to the settings that were in effect at the time the router was shipped from the factory. Any settings that have not been saved will be lost, including any rules that you have created. If you want to save the current router configuration settings, use the Save

button above.

Reboot Device: Click to reboot the router.

D-Link DIR-628 User Manual

59

Image 59
Contents Page Trademarks PrefaceManual Revisions Table of Contents Networking Basics Wireless SecurityTroubleshooting Wireless Basics Technical SpecificationsProductPackageOverviewContents Browser Requirements System RequirementsTotal Performance IntroductionFeatures Connections Hardware OverviewWCN LED LEDsBefore you Begin InstallationWireless Installation Considerations Turn on your computer Connect to Cable/DSL/Satellite ModemConnect to Another Router Installation Getting Started Web-based Configuration Utility ConfigurationClick Internet Connection Setup Wizard to begin Setup WizardConfiguration Configuration Configuration Dynamic Cable Manual ConfigurationConnection Internet SetupPptp Page L2TP Page Static assigned by ISP Mode 2.4GHz Wireless SettingsChannel Scan IP Address Subnet Mask Device Name Network SettingsDhcp Server Settings Secondary Wins IP Address TypeClients Dhcp ReservationPage Virtual Server Configuration Port Forwarding Application Rules QoS Engine Enable Traffic Traffic ShapingClassification Network Filters Access Control Access Control Wizard Access Control Wizard Add Website Select Allow or Deny Filtering Rule Website FiltersInbound Filters Firewall Settings Application Level Gateway Configuration Routing Advanced Wireless Settings Default Wi-Fi Protected SetupDevice Wizard Inbound Filter Advanced Network SettingsUPnP Administrator Settings Time Settings Check this box to send the router logs to a SysLog Server SysLogSmtp Server Address Email SettingsEnable Email Notification From Email Address Account Name Password On Log Full On ScheduleFile name for the settings System SettingsUpdate Firmware Ddns System Check Schedules Device Information Save Log Apply Log Settings RefreshLog Stats Internet Sessions Page Wireless Support What is WPA? Wireless SecurityLaunch Wireless Security Setup Wizard Wireless Security Setup WizardIf you selected Manually, the following screen will appear Add Wireless Device with WPS Wizard Configure WPA-Personal PSK Configure WPA-Enterprise Radius Security Using Windows Vista Connect to a Wireless NetworkConfigure Wireless Security Security Connect Using WCN 2.0 in Windows Vista Using Windows XP Configure WPA-PSK Connecting to a Wireless Network Why can’t I access the web-based configuration utility? TroubleshootingWhat can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics Wireless Personal Area Network Wpan Wireless Local Area Network WlanSmall Office and Home Office HomeSecurity Centralize your router or Access PointEliminate Interference Wireless Modes Check your IP address Networking BasicsStep Highlight Internet Protocol TCP/IP and click Properties StepWireless Signal Rates1 Ieee 802.11n draft 2.0 HT20/HT40 Technical SpecificationsFCC Caution CE Mark WarningFCC Statement IC Radiation Exposure Statement IC statement