D-Link DIR-68 manual

Page 68

Section 3 - Configuration

Dir: The direction of initiation of the conversation:

Out - Initiated from LAN to WAN.

In - Initiated from WAN to LAN.

Priority: The preference given to outbound packets of this conversation by the QoS Engine logic. Smaller numbers represent higher priority.

Time Out: The number of seconds of idle time until the router considers the session terminated. The initial value of Time Out depends on the type and state of the connection.

300 seconds - UDP connections.

240 seconds - Reset or closed TCP connections. The connection does not close instantly so that lingering packets can pass or the connection can be re-established.

7800 seconds - Established or closing TCP connections.

D-Link DIR-628 User Manual

68

Image 68
Contents Page Trademarks PrefaceManual Revisions Table of Contents Wireless Security Troubleshooting Wireless BasicsTechnical Specifications Networking BasicsProductPackageOverviewContents System Requirements Browser RequirementsIntroduction Total PerformanceFeatures Hardware Overview ConnectionsLEDs WCN LEDInstallation Before you BeginWireless Installation Considerations Connect to Cable/DSL/Satellite Modem Turn on your computerConnect to Another Router Installation Getting Started Configuration Web-based Configuration UtilitySetup Wizard Click Internet Connection Setup Wizard to beginConfiguration Configuration Configuration Manual Configuration Dynamic CableInternet Setup ConnectionPptp Page L2TP Page Static assigned by ISP Wireless Settings Mode 2.4GHzChannel Scan Network Settings IP Address Subnet Mask Device NameDhcp Server Settings Type Secondary Wins IP AddressDhcp Reservation ClientsPage Virtual Server Configuration Port Forwarding Application Rules Enable Traffic Traffic Shaping QoS EngineClassification Network Filters Access Control Access Control Wizard Access Control Wizard Website Filters Add Website Select Allow or Deny Filtering RuleInbound Filters Firewall Settings Application Level Gateway Configuration Routing Advanced Wireless Settings Wi-Fi Protected Setup DefaultDevice Wizard Inbound Filter Advanced Network SettingsUPnP Administrator Settings Time Settings SysLog Check this box to send the router logs to a SysLog ServerEmail Settings Enable Email Notification From Email AddressAccount Name Password On Log Full On Schedule Smtp Server AddressSystem Settings File name for the settingsUpdate Firmware Ddns System Check Schedules Device Information Save Log Apply Log Settings RefreshLog Stats Internet Sessions Page Wireless Support Wireless Security What is WPA?Wireless Security Setup Wizard Launch Wireless Security Setup WizardIf you selected Manually, the following screen will appear Add Wireless Device with WPS Wizard Configure WPA-Personal PSK Configure WPA-Enterprise Radius Security Connect to a Wireless Network Using Windows VistaConfigure Wireless Security Security Connect Using WCN 2.0 in Windows Vista Using Windows XP Configure WPA-PSK Connecting to a Wireless Network Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics Wireless Local Area Network Wlan Wireless Personal Area Network WpanHome Small Office and Home OfficeSecurity Centralize your router or Access PointEliminate Interference Wireless Modes Networking Basics Check your IP addressStep Step Highlight Internet Protocol TCP/IP and click PropertiesTechnical Specifications Wireless Signal Rates1 Ieee 802.11n draft 2.0 HT20/HT40FCC Caution CE Mark WarningFCC Statement IC statement IC Radiation Exposure Statement