D-Link DIR-68 manual L2TP

Page 26

Section 3 - Configuration

Internet Setup

L2TP

Choose L2TP (Layer 2 Tunneling Protocol) if your ISP uses a L2TP connection. Your ISP will provide you with a username and password. This option is typically used for DSL services.

Address Mode: Select Static if your ISP assigned you the IP address, subnet mask, gateway, and DNS server addresses. In most cases, select Dynamic.

L2TP IP Address: Enter the L2TP IP address supplied by your ISP (Static only).

L2TP Subnet Mask: Enter the Subnet Mask supplied by your ISP (Static only).

L2TP Gateway: Enter the Gateway IP Address provided by your ISP.

L2TP Server IP: Enter the Server IP provided by your ISP (optional).

Username: Enter your L2TP username.

Password: Enter your L2TP password and then retype the password in the next box.

Reconnect Mode: Select either Always-on,On-Demand, or Manual.

Maximum Idle Time: Enter a maximum idle time during which the Internet connection is maintained during inactivity. To disable this feature, enable Auto-reconnect.

DNS Servers: Enter the Primary and Secondary DNS Server Addresses (Static

L2TP only).

D-Link DIR-628 User Manual

26

Image 26

Contents Page Trademarks PrefaceManual Revisions Table of Contents Technical Specifications Wireless SecurityTroubleshooting Wireless Basics Networking BasicsProductPackageOverviewContents System Requirements Browser RequirementsIntroduction Total PerformanceFeatures Hardware Overview ConnectionsLEDs WCN LEDInstallation Before you BeginWireless Installation Considerations Connect to Cable/DSL/Satellite Modem Turn on your computerConnect to Another Router Installation Getting Started Configuration Web-based Configuration UtilitySetup Wizard Click Internet Connection Setup Wizard to beginConfiguration Configuration Configuration Manual Configuration Dynamic CableInternet Setup ConnectionPptp Page L2TP Page Static assigned by ISP Wireless Settings Mode 2.4GHzChannel Scan Network Settings IP Address Subnet Mask Device NameDhcp Server Settings Type Secondary Wins IP AddressDhcp Reservation ClientsPage Virtual Server Configuration Port Forwarding Application Rules Enable Traffic Traffic Shaping QoS EngineClassification Network Filters Access Control Access Control Wizard Access Control Wizard Website Filters Add Website Select Allow or Deny Filtering RuleInbound Filters Firewall Settings Application Level Gateway Configuration Routing Advanced Wireless Settings Wi-Fi Protected Setup DefaultDevice Wizard Inbound Filter Advanced Network SettingsUPnP Administrator Settings Time Settings SysLog Check this box to send the router logs to a SysLog ServerAccount Name Password On Log Full On Schedule Email SettingsEnable Email Notification From Email Address Smtp Server AddressSystem Settings File name for the settingsUpdate Firmware Ddns System Check Schedules Device Information Save Log Apply Log Settings RefreshLog Stats Internet Sessions Page Wireless Support Wireless Security What is WPA?Wireless Security Setup Wizard Launch Wireless Security Setup WizardIf you selected Manually, the following screen will appear Add Wireless Device with WPS Wizard Configure WPA-Personal PSK Configure WPA-Enterprise Radius Security Connect to a Wireless Network Using Windows VistaConfigure Wireless Security Security Connect Using WCN 2.0 in Windows Vista Using Windows XP Configure WPA-PSK Connecting to a Wireless Network Troubleshooting Why can’t I access the web-based configuration utility?What can I do if I forgot my password? Troubleshooting Troubleshooting Wireless Basics Wireless Local Area Network Wlan Wireless Personal Area Network WpanHome Small Office and Home OfficeSecurity Centralize your router or Access PointEliminate Interference Wireless Modes Networking Basics Check your IP addressStep Step Highlight Internet Protocol TCP/IP and click PropertiesTechnical Specifications Wireless Signal Rates1 Ieee 802.11n draft 2.0 HT20/HT40FCC Caution CE Mark WarningFCC Statement IC statement IC Radiation Exposure Statement