FARGO electronic Resolving ANEG Settings and Printing Problems with Fargo Electronics Inc.

RESTRICTED USE ONLY Fargo Electronics, Inc.

Changing the DHCP Setting

Step Procedure

1See the Accessing the Network Setup Menu procedure to access the Network Settings menu :

Options -> MENU -> Next -> Network Settings

2Select Next on the LCD to view the DHCP menu entry.

•DHCP Enabled indicates that the automatic IP assignment is selected.

•DHCP Disabled indicates that the static IP assignment is selected.

3Press the Change button to switch the DHCP setting.

4If you change the setting, you will be prompted to reboot the Printer.

Changing the ANEG setting

The ANEG status indicates the current setting of the network configuration of the Ethernet interface.

•This value can be set explicitly by the User to force the Ethernet interface configuration in cases where auto negotiation fails.

•Failure of the automatic network configuration can cause slow data transmission, longer print times or network connection problems.

Follow the procedure provided below.

Step	Procedure
1	See the Accessing the Network Setup Menu procedure to access the
	Network Settings menu (Options ->Menu -> Next -> Network Settings).
2	Select Next on the LCD to view the ANEG: menu entry.
3	Press the Change button to change the auto negotiation setting for the
	Printer, which will rotate between the following:
	• ANEG: AUTO: Allows the auto negotiation between the Printer and the
	host Ethernet interface.
	• ANEG: Full Dup: Forces the full duplex communications between the
	Printer and the host Ethernet interface.
	• ANEG: Half Dup: Forces the half duplex communications between the
	Printer and the host Ethernet interface.
4	If you change the setting, you will be prompted to reboot the Printer.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2)		6-51