FARGO electronic HDP5000 manual Installing the Card Lamination Module, Introduction

RESTRICTED USE ONLY Fargo Electronics, Inc.

Installing the Card Lamination Module

Introduction

The following guide provides a step-by-step installation procedure for the HDP5000 Lamination Module and Printer Driver Accessory. Refer to the HDP5000 High Definition Card Printer/Encoder User Guide for details on operating your new card Lamination Module.

The time required for each installation is provided below:

•Lamination Module Installation (time required): This hardware installation process will require approximately 10 to 15 minutes.

•Driver Software Installation (time required): This software installation process will require approximately 2 to 6 minutes (depending on the speed of your PC).

The System Requirements are as follows:

•IBM-PC or compatible, Windows® 2K/XP/., Pentium® class 500MHz computer with 256MB of RAM or higher, 500MB free hard disk space or higher and USB 1.1

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 7-4