FARGO electronic HDP5000 manual Inspecting the Card Lamination Module, Choosing a proper Location

RESTRICTED USE ONLY Fargo Electronics, Inc.

Inspecting the Card Lamination Module

While unpacking your Lamination Module, inspect the carton to ensure that no damage has occurred during shipping. (Note: Make sure that all supplied accessories are included with your unit.)

Your new Lamination Module is packaged in a standard HDP5000 Card Printer/Encoder carton. (Note: It is recommended that you save the packaging in the event that you need to transport the Card Printer/Encoder/Laminator at a future date.)

Unpacking the Card Lamination Module

The following items are included with your new Lamination Module:

•Card Lamination Module

•Power Supply with a Power Cord (for the Card Lamination Module)

•Warranty Card

•Registration Card

Choosing a proper Location

Follow these guidelines:

•Place the unit in a location with adequate air circulation to prevent internal heat build-up.

•Use the Printer's dimensions (10.75 H x 35.5 W x 13 D) as a guideline for the minimum clearances to the unit. (Note: Allow for adequate clearance above the unit to accommodate the height of the unit with its Covers open.)

•Do not install the unit near heat sources, such as, radiators or air ducts.

•Do not install the unit in a place subject to direct sunlight, excessive dust, mechanical vibration or shock.

Preventing Moisture Condensation

If the unit is brought directly from a cold to a warm location or if the unit is placed in a very damp room, moisture may condense inside the unit. (Note: If this condition occurs, print quality may not be at its optimum level.)

Follow this guideline:

•Leave the unit turned OFF in a warm, dry room for several hours before using it. (Note: This will allow the moisture to evaporate.)

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 7-5