FARGO electronic HDP5000 manual Troubleshooting with the LCD Error Message Table

RESTRICTED USE ONLY Fargo Electronics, Inc.

Troubleshooting with the LCD Error Message Table (continued)

LCD Error Message	Cause	Solution
Head Resistance	The EE setting in Driver for	Enter a value for head
(PC Error Message	head resistance is out of	resistance in the EE settings in
	range.	the Driver.
No. 6)
		Reset the correct value
		according to the steps in the
		Troubleshooting Section.
		If this problem persists, call for
		technical assistance.
Head Sensor Error	The Printhead Temperature	If the problem persists, call for
(PC Error Message	Sensor is not functioning or	technical assistance.
	is not connected properly.
No. 8)
	OR
	The Printhead is not cooling
	properly.
Head Voltage Err	A hardware fault has	Reset the Printer and try
(PC Error Message	prevented setting the correct	again.
	Printhead voltage.	If this problem persists, call for
Nos. 103 and 105)
		technical assistance.
Headlift Error	This is a problem with the	Reset the Printer and try
(PC Error Message	Printhead Lift or Transfer	again.
	Roller Headlift.
Nos. 102, 103, 104,		If this problem persists, call for
and 105)		technical assistance.
Heater Error	The Transfer Heater Roller is	Reset the Printer and try
(PC Error Message	too hot.	again.
No. 161)		If this problem persists, call for
		technical assistance.

HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.2) 5-10